Advertisement

Quick Links

Bbd43 (UL)

PRODUCT SAFETY

When using electrical equipment, basic safety precautions should always be followed, including the following:
READ THESE INSTRUCTIONS BEFORE USING THIS PRODUCT.
This product must be installed in accordance with
applicable installation codes by a person familiar
with the construction and operation of the product
and the hazards involved.
To avoid risk of electrical shock, disconnect light
luminaire power before connecting BBD43 unit
before installing,wiring, or servicing hardware.
If you attach a safety cable, attach it to the
luminaire in accordance with all national, state,
and local construction codes.
Do not use luminaire or BBD43 if the housing,
suspension cables, optics, or power cables
are damaged.
Do not touch or scratch the luminaire optics, as
you may damage the optical coating. To clean the
module, use a damp cloth and gently swab the
affected area.
Handle luminaire only by the end caps. Do not
grasp or handle luminaire by the light bars or
BBD43 unit housing.
The light source contained in the luminaire shall
only be replaced by the manufacturer, his service
agent, or another qualified person.
The battery is non-replaceable.
SAVE THESE INSTRUCTIONS.
Replace BBD43 unit when luminaire no longer
runs for required backup time. Follow
disconnect instructions and contact a Digital
Lumens representative.
Note the maximum mounting height for DLE
luminaires with BBD43
DLE-12/18/24 — 58 ft (17.7 m)
DLE-48 — 77 ft (23.5 m)
Do not use outdoors.
Do not mount near gas or electric heaters.
Use caution when servicing batteries. Battery acid
can cause burns to skin and eyes. If acid is spilled
on skin or eyes, flush acid with fresh water and
contact a physician immediately.
Equipment should be mounted in locations and at
heights where it will not be subjected to tampering
by unauthorized personnel.
The use of accessory equipment not
recommended by manufacturer may cause an
unsafe condition.
Do not use this equipment for other than its
intended use.
:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BBD43 and is the answer not in the manual?

Questions and answers

Summary of Contents for Digital Lumens BBD43

  • Page 1 Do not use outdoors. and local construction codes. Do not mount near gas or electric heaters. Do not use luminaire or BBD43 if the housing, Use caution when servicing batteries. Battery acid suspension cables, optics, or power cables can cause burns to skin and eyes. If acid is spilled are damaged.
  • Page 2 INSTALLATION INSTRUCTIONS BBD43 Emergency DLE-48 light bar (1) BBD43 (1) Emergency DLE-12 DLE-18 DLE-24 light bar BBD43 BBD43 BBD43 Emergency Emergency light bar light bar BBD43 (2) Emergency light bar (1) DLE-12/18/24/48 (primary end) DLE-48 (secondary end) BBD43 Installation Instructions...
  • Page 3 BBD43 (UL) INSTALLATION INSTRUCTIONS BBD43 (cont.) Remove Screw BBD43 Unit DLE Luminaire BBD43 Installation Instructions...
  • Page 4 BBD43 (UL) INSTALLATION INSTRUCTIONS BBD43 (cont.) Bottom retention hook and screw location Test Button and LED Status Indicator Reset Button BBD43 Installation Instructions...
  • Page 5 Observe the location of the designated emergency light bar, compartments. Ensure all wires are tucked safely into the and the correct placement of the BBD43 unit(s), on each DLE luminaire wiring compartment (Illustration 10). luminaire. If installing BBD43 on an uplight luminaire, ensure...
  • Page 6 You must connect the luminaire to facility power in order to test the BBD43 battery. Press and hold the TEST button on the BBD43 – for no more than 2 seconds – until the LED status indicator blinks (alternating red/green), and then release (Illustration 14).

This manual is also suitable for:

Bbd43 ul

Table of Contents