Advertisement
Specifications
assembly
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO prEVEnt SEriOUS inJUry:
Scaffold components from other manufacturers must not be used with this Scaffold.
Safety equipment added to this Scaffold, such as rails, toe guards, stability strapping,
and safety harnesses, must be installed by a qualified technician. they must fit together
without being forced, and the Scaffold's structural integrity must be maintained.
note: For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 10.
1. Mount the Swivel Casters (4) to the bottom of the
End Frames (1) by sliding each Swivel Caster (4)
into a leg and securing it with a Locking Pin (5).
Then snap the Pin Spring (6) around the end of the
Locking Pin to keep it in place. Refer to Figure A.
Locking pin (5)
pin Spring (6)
Figure a
Page 4
Maximum Capacity
Scaffold Stackable
Adjustable Mounting Holes
Platform Height
End Frame (1)
Swivel Caster (4)
For technical questions, please call 1-888-866-5797.
900 lb. for Single Stage
Up To Two Levels Only
1/2" Diameter (30 Per Side)
28" to 48" High, Single Stage
2. Slide a Side Rail (2) onto an End Frame and
secure in place using Height Adjustment Pin (7)
and a Locking Pin and Pin Spring. Secure
the other end of the Side Rail to the other End
Frame in the same manner. Refer to Figure B.
MaKE SUrE tHE pinS FULLy EnGaGE.
Repeat procedure for the other Side Rail.
Height
adjustment
pin (7)
Figure B
Side
rail (2)
Locking pin
& pin Spring
Item 63051
Advertisement
