Ram Mounts HandStand RAM-GDS-HS1U Assembly Manual

For a video demonstration of this assembly, visit www.rammount.com/part/RAM-GDS-HS1U
The RAM® HandStand is compatible with any IntelliSkin™
that features the unique circular interface on the back.
2. Insert Nut into center nut pocket of Slip Washer.
White nylon inside Nut must be facing upward.
For a video demonstration of this assembly, visit www.rammount.com/part/RAM-GDS-HS1U
The RAM® HandStand is compatible with any IntelliSkin™
that features the unique circular interface on the back.
2. Insert Nut into center nut pocket of Slip Washer.
White nylon inside Nut must be facing upward.
RAM® HandStand™Assembly Guide
1. Shift hand strap to the side to expose screw head. Loosen screw with screwdriver to disassemble:
3. Insert Slip Washer with Nut into center hole of
your IntelliSkin™.
RAM® HandStand™Assembly Guide
1. Shift hand strap to the side to expose screw head. Loosen screw with screwdriver to disassemble:
3. Insert Slip Washer with Nut into center hole of
your IntelliSkin™.
Slip Washer HandStand™
Nut
4. While holding Nut in place, reassemble the
RAM® HandStand™ from the outside of your
IntelliSkin™, fully tightening down on the screw.
RPR-INS-GDS-HS1
HandStand™
Slip Washer
Nut
4. While holding Nut in place, reassemble the
RAM® HandStand™ from the outside of your
IntelliSkin™, fully tightening down on the screw.
RPR-INS-GDS-HS1