Zephyr POP-UP MARQUEE Assembly Instructions

Advertisement

FITTING CANOPY

1, Remove frame from bag and place on at ground. Open frame out slightly by pulling the legs
outwards from the centre until it is extended about 4' x 4' . (120cm x 120cm) (Fig 1)
2, Lay the roof canopy centrally over the frame. (Fig 2)
3, Gradually open the frame out a bit more by lifting up frame by the triangle joint section indicated
and stepping outwards. (Fig 3)
4, Once the frame is extended out to halfway, 5' x 5' (150cm x 150cm), Align the corner
reinforcements with the corner sections on the top of the frame (Fig 4). Secure the velcro strips
to on the frame to the strips in the corners of the canopy.
5, Extend the frame out further, pausing to enclose the centre top point into the little reinforced
'bag' in the centre of the canopy roof. (Fig 5)
6, Once secure, pull the frame out to full position. (Fig 6) Slide the black corner connectors up till they
click in place. (Fig 7)
7, Pull down the valance in the corners to straighten and make it taut. (Fig 8)
8, If required, turn the handle in the centre of the frame to raise the top point of the canopy to it's
maximum height. (Fig 9)
9, Ensure that the canopy is sitting correctly. Stand on the metal feet and raise the legs to full height
making sure they click into place. (Fig 10) Ideally raise two legs on the same side at a time.
10, Once the canopy is at full height, (Fig 11), use the velcro inside to wrap around the frame and
secure the canopy to it's frame. (Fig 12)
Fig 1
Fig 1
Fig 5
Fig 5
Fig 9
Fig 9
MINIMUM TWO PEOPLE REQUIRED FOR ASSEMBLY
Fig 2
Fig 2
Fig 6
Fig 6
Fig 10
Fig 10
September 2016 v1
Fig 3
Fig 3
Fig 7
Fig 7
Fig 11
Fig 11
3m x 3m
Fig 4
Fig 4
Fig 8
Fig 8
Fig 12
Fig 12

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the POP-UP MARQUEE and is the answer not in the manual?

Questions and answers

Summary of Contents for Zephyr POP-UP MARQUEE

  • Page 1 3m x 3m September 2016 v1 MINIMUM TWO PEOPLE REQUIRED FOR ASSEMBLY FITTING CANOPY 1, Remove frame from bag and place on at ground. Open frame out slightly by pulling the legs outwards from the centre until it is extended about 4’ x 4’ . (120cm x 120cm) (Fig 1) 2, Lay the roof canopy centrally over the frame.
  • Page 2 Always secure the Pop-up marquee to the ground Frame weight 18.2kg using either pegs / stakes or weight bags. Canope weight 3.4kg Do not use the Pop-up Marquee in windy weather Panel weight (half wall) 0.7kg Let the marquee dry fully before storing away (full wall) 1.5kg Only use mild detergent and water to clean the graphics.

Table of Contents