Satellite PolyPortables TAG4 Assembly Instructions

* HDWE- TAG4 CART ( 23487 )
5 11368 8 WASHER- 5/16 FLAT STNLS
4 20840 4 NUT- 5/16-18 NYLOC STNLS
3 23489 4 BOLT, 5/16-18 X 2 HXHD STNLS
ITEM PART# QTY DESCRIPTION
2 23487 1 HDWE- TAG4 CART
1 23484 1 CART ASSY- TAG4
ITEM PART# QTY DESCRIPTION
TOOLS: - DRILL - ½" DRILL BIT - ½" WRENCHES (2)
Assemble Cart To Sink
1. Drill (2) holes with ½ inch drill bit at indicated locations in sink base.
2. Place sink on cart and align holes.
3. Insert bolts with washers through holes from below.
4. Tighten nuts and bolt until snug. Do not over tighten.
** SEE PAGE 2 IF CART REQUIRES ASSEMLBY **
7/2020
TAG4 CART
ASSEMBLY INSTRUCTIONS
*
TIGHTEN BOLTS AND NUTS UNTIL SNUG
2530 Xenium Lane North, Minneapolis, MN 55441
Telephone: 763-553-1900
800-328-3332 / www.satelliteindustries.com
REV A 23488 INSTRUCTIONS TAG4 CART
DRILL AT DRILL POINT
EACH END
BOLT (4)
3
Fax: 763-553-1905
4
NUT (4)
5
WASHER (8)
1
ALUMINUM PLATE
1