Ho do I replace the two pieces at the bottom of the blade guard on a Victo Commando edger
1 comments:
Mr. Anderson
May 14, 2025
To replace the two pieces at the bottom of the blade guard on a Victa Commando edger:
1. Remove the blade guard if necessary. 2. Reposition the blade guard so the outer edge of the guard aligns with the left-hand edge of the baseplate. 3. Set the height adjustment in the third notch from the bottom. 4. Ensure the lower edge of the blade guard is parallel to the ground. 5. Use replacement part number AF07276A if a new part is needed.
Make sure all parts are securely fastened before using the edger.
Need help?
Do you have a question about the TILT-A-CUT and is the answer not in the manual?
Questions and answers
Carburetor spares.
The available carburetor spares for the Victa TILT-A-CUT include:
- CARBURETTOR ASSY. CR03676A (Small Snorkel)
- CARBURETTOR ASSY. CR03697A (Large Snorkel)
- CARBURETTOR ASSY. CR03678A
This answer is automatically generated
Ho do I replace the two pieces at the bottom of the blade guard on a Victo Commando edger
To replace the two pieces at the bottom of the blade guard on a Victa Commando edger:
1. Remove the blade guard if necessary.
2. Reposition the blade guard so the outer edge of the guard aligns with the left-hand edge of the baseplate.
3. Set the height adjustment in the third notch from the bottom.
4. Ensure the lower edge of the blade guard is parallel to the ground.
5. Use replacement part number AF07276A if a new part is needed.
Make sure all parts are securely fastened before using the edger.
This answer is automatically generated