Advertisement
Maxon Radio and Turf Guard Receiver Installation
Figure 4
A
C
Maxon Radio Install
Step 1 – Disconnect all cables attached to the radio assembly.
Step 2 – Remove the radio components from the old bracket marked A, B and C.
Step 3 – Install the radio components A, B and C on the new radio bracket. Note the two locations where a lock nut is used instead of a screw. See Figure 5.
Step 4 – Position the bracket's lower tab into the center back plate's access hole and align the top tabs into the distribution board's top mounting tabs. Secure with
the provided screw nuts.
Step 5 – Reconnect the cables to the radio assembly and check for proper function.
Turf Guard Radio Install
Step 1 – Disconnect the cable from the Turf Guard Repeater assembly and position it on the distribution bracket tab as indicated in Figure 6. Secure the assembly
with the bolt and provided bolt nut. It might be necessary to drill a 1/4" hole in the Turf Guard Repeater bracket to accommodate the mounting bolt.
Step 2 – Reconnect the cable to the Turf Guard Repeater assembly and check for proper function.
© 2013 The Toro Company • Irrigation Division • www.toro.com
Figure 5
Install Radio Components
and Bracket to the
Satellite
B
Remove Radio
Components
B
C
A
Figure 6
Install Turf Guard
Repeater
Part Number 373-0802 Rev. A
Advertisement
