Infinite Innovations Sneeze Guard Installation Instructions

Congratulations on your purchase of our high quality vehicle specific Sneeze Guard. Designed to fit your vehicle with minimal
clearance around the circumference of the shield. Bent for added strength and to fit tight against the seat back for passenger clearance.
I n s t a l l a t i o n I n s t r u c t i o n s
See back page for strap instructions
W W W. I N F P A R T S . CO M •
S n e e z e G u a r d
There are two installation holes for optional drivers
height adjustment:

Height (1)

Strap placement used when drivers prefer the seat
raised and closer to the wheel.
for the shield not to mash into the headliner with
seat raised.
Height (1)

Height (2)

Most commonly used strap position for drivers that
Height (2)
drive with the seat lowered in a more common
position of stature, especially for tall drivers.
For the slots not used:
They make the perfect location to mount the
Infinite tissue holder pictured. Tissue Holder sold
separately. Part number CHA1700KIT.

Installing the Sneeze Guard in your vehicle:

Remove the protective coating off both sides of the
Sneeze Guard.
Install the supplied straps for mounting in the
desired holes necessary for the drivers height. Leave
the strap long so they can be easily snapped together
during installation.
If you have purchased our tissue holders. Using
the additional holes clip the tissue holder in place
before installing the shield into the vehicle.
Raise the headrest for room to connect and tighten
the straps. With a person in the backseat holding the
shield in place clip the strap together in front of the
headrest bars and tighten the strap. Lower the head-
rests and your installation is now complete.
1-800-362-6224
is allows clearance