Geek My Tree GlowFlakes Setup & User Manual

Setup instructions
1
Before placing the
hanging ring on the
tree, make sure the
direction arrow is
facing the front.
2
Split strands into
two groups then
place the hanging
ring on the top of
the tree. When
secured in place,
equally spread the
strands around
the tree.
3
Plug the power
cord into the
hanging ring and a
wall outlet.
4
Make sure the
infrared sensors
on the hanging
ring are not
blocked.
Remove the
plastic battery tab
on the remote.
Press the Power
button to start the
show.
Using the remote
Power Turns the unit on and off.
Time
Each press increases the effect
time by 1 minute. The maximum
time is 5 minutes per effect.
Animated Show effects with movement.
Gradient Show non-moving color blends.
Color Show solid colors.
Next Skips to the next effect.
Erase Press to remove effects you do
not wish to display on the tree.
To restore all effects, hold until
lights flash white.
Shuffle Randomly selects effects from all
effect groups. Erased effects will
not play in shuffle mode.
Questions & answers
Q: How do I show just a single effect?
A: Erase all other effects in that effect group.
Q: Why do I get blinking red lights when I'm erasing effects?
A: GlowFlakes require at least one effect in each effect group. Blinking red
lights indicating you can not remove any additional effects.
Q: Can I restore a single erased effect?
A: No, reset will restore them all. To restore, hold the Erase button down for 5
seconds. When the lights flash white, all effects have been restored.
Q: Do I lose my setting if I unplug the unit?
A: No, all settings are stored in memory.
Q: How can I use GlowFlakes on a tree shorter than 7½ feet?
A: Zig-Zag GlowFlakes in and out of the tree.
Q: Can I use GlowFlakes outside?
A: No. GlowFlakes are for indoor use only.
Q: How do I reach support?
A: Email: support@geekmytree.com
Phone: 616-303-0220 (during normal business hours)
www.geekmytree.com