Summary of Contents for D&M SLASHBUSTER
- Page 1 “SLASHBUSTER” ® Maintenance D&M Machine Division, Inc. 12 Monte-Brady RD Montesano, WA 98563 360-249-3366-Phone 360-249-1171-Fax...
- Page 2 Note: Keep spindle bearings adjusted to zero endplay...check daily. Note: Keep teeth sharp as per enclosed instructions. Note: Grease bearing housing daily.
- Page 3 Daily Maintenance Program Check the “SLASHBUSTER” daily for damage, cracks, loose or worn parts, nuts and bolts. Repair, replace or tighten as necessary. Check the shaft and bearings by pushing on the cutting wheel while watching for bearing play. Adjust out all movement using the adjusting nuts and lock in place.
- Page 4 ® run for 5 minutes to lubricate the top of bearing. 6. It is the responsibility of the owner or operator to perform these maintenance functions and to operate the “SLASHBUSTER” ® within its limitations. See operator’s manual.
Need help?
Do you have a question about the SLASHBUSTER and is the answer not in the manual?
Questions and answers