Subscribe to Our Youtube Channel
Related Manuals for IMC F63/502
Summary of Contents for IMC F63/502
- Page 1 MOBILE HAND WASH UNIT INSTALLATION, OPERATION & MAINTENANCE MANUAL PLEASE LEAVE WITH OPERATOR MOBILE HAND WASH UNIT – F63/502 IS761 ECN 4744 - June 2020...
-
Page 2: Inportant Information
INDEX INPORTANT INFORMATION Guarantee Delivery DIMENTIONS SPECIFICATION PRODUCT FEATURES INSTALLATION Procedure Location Electrical Connection Commissioning 6 - 7 Emptying / Refilling / Draining 7 - 8 Cleaning SPARE PARTS Spare Parts List Ordering Spear Parts... - Page 3 Funnel with flexible spout Water container 20L - Natural Drain adapter Instruction Booklet Please notify LINCAT-IMC on the day of receipt if anything is missing or damaged. UK: 01522 875555 Check that the correct machine has been supplied. The data plate is located on...
- Page 4 MOBILE HAND WASH UNIT DIMEMSIONS SPECIFICATION Part No. F63/502 Power rating 3 kW Voltage 230 V ~50 Hz Tank Capacity 20 litres Net Weight 33.6kg Water Temperature...
- Page 5 MOBILE HAND WASH UNIT PRODUCT FEATURES TOWEL HOLDER SOAP HOLDER WATER SPOUT SINK SURROUND MANUAL FILL COVER ACCESS KNOB WATER LEVEL WHEEL FOOT PUMP...
- Page 6 INSTALLATION These Instructions contain important information designed to help the user obtain the maximum benefit from their investment in an IMC Mobile Hand Wash Unit. Please read them carefully before starting work and consult with your distributor/supplier in the event of any queries.
- Page 7 MOBILE HAND WASH UNIT Electricity Supply Connection Position the unit at the chosen site, the electricity supply connection should be made to a power outlet socket or isolator mounted on the wall close to the machine. This socket or isolator must be accessible once the machine is installed. Before connecting, check that the voltage shown on the rating is correct for the electricity supply you have available.
- Page 8 MOBILE HAND WASH UNIT USING YOUR IMC MOBILE HAND WASH UNIT Commissioning Firstly; ensure that the unit is unplugged from any power source before following the steps outlined below. Remove the front panel by unscrewing the black knob, tilt the panel backwards and pull away from the unit at an upward angle.
- Page 9 MOBILE HAND WASH UNIT Power the unit up by connecting it to a suitable power source. Once the unit has been connected, the element in the hot water tank will start heating up the water immediately; it should take approximately 15 minutes to reach operating temperature on a full tank of water.
- Page 10 MOBILE HAND WASH UNIT To drain Connect the adapter finger tight on to the drain valve and position a suitable container to collect the water. Open the tap and allow enough time for the water to flow out. Close the tap and remove the adapter and place it back in its stowing position. Ensure that the waste water is disposed of appropriately.
-
Page 11: Spare Parts
SERIES AND SERIAL NUMBER of the machine. This is to be found on the rating plate located near the supply cable if applicable or at the rear of the appliance. For help with the installation, maintenance and use of your Lincat - IMC equipment, please contact our service department: UK:...
Need help?
Do you have a question about the F63/502 and is the answer not in the manual?
Questions and answers