Harbor Freight Tools Pittsburgh 614405 Owner's Manual & Safety Instructions page 3

ASSEMBLY INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
document including all text under subheadings therein before set up or use of this product.
The Hydraulic Lift Table requires some
assembly after you unpack it.
Lock Nuts (14)
Washer (15)
Bushing (48)
Hex Bolts (16)
Figure 1
1. First, set aside the hardware needed to
install the Front Wheels (47). The hardware
includes the Hex Bolts (16), Lock Nuts (14),
Washers (15), and Bushings (48).
Wheel
Frame
Front Wheel
(47)
Lock Nut (14)
Figure 2
2. Turn Lift Table on its side. Slide Bushing through
center hole in the Front Wheel. Then set Front Wheel
in the wheel frame of the Base Assembly (17).
Slide the Hex Bolt through the Washer, wheel
frame and Bushing. Use a wrench (sold separately)
to fasten Lock Nut onto Hex Bolts, until the
Front Wheel is secured into place.
Item 61405
Front
Wheels
(47)
Wrench
Washer (15)
For technical questions, please call 1-888-866-5797.
Wrench
Figure 3
3. Slide Lifting Pedal (27) into Pedal
Connector (30a), aligning the installation holes.
Then slide the Bolt (29) through the Washer (15)
and through the installation holes. Use the
wrench to fasten the Lock Nut (12) over the Bolt,
securing Lifting Pedal in place. See Figure 3.
Wrench
Bolt (20)
Figure 4
4. Slide the ends of the Handle (21) into the
handle slots on the Base Assembly (17).
Use the wrench to tighten the Bolts (20) until Handle
is securely fastened in place. See Figure 4.
5. WARNING! TO PREVENT SERIOUS INJURY:
After assembly, try out the Lift Table to make sure it
is functioning properly before using it to lift a load.
Lifting Pedal
Connector
(30a)
Lifting
Bolt (29)
Pedal
(27)
Handle
(21)
Base
Assembly
(17)
Page 3