Subscribe to Our Youtube Channel
Related Manuals for Hypertherm PAC200T
Summary of Contents for Hypertherm PAC200T
- Page 1 PAC200T/E Torch Handle Replacement Field Service Bulletin 804830 – Revision 0 – June, 2004 Hypertherm, Inc. Etna Road, P.O. Box 5010 Hanover, NH 03755 USA 603-643-3441 Tel 603-643-5352 Fax www.hypertherm.com...
- Page 2 Disconnect electrical power before performing any maintenance. See Section 1 of the Instruction Manual for more safety precautions. Introduction Purpose Describes necessary steps to replace damaged handles on the PAC200T and PAC200E hand torch. Tools And Materials Needed #2 Phillips screw driver Kit Contents...
- Page 3 Install Handles Place CE/CSA label on right handle. Place PAC200T or PAC200E label on left handle as appropriate. Place torch into right handle and route wires as shown above. Note: Route start switch wires underneath the torch body gas tubes.
- Page 4 © Copyright 2004 Hypertherm, Inc. All Rights Reserved Hypertherm and Powermax are trademarks of Hypertherm, Inc. and may be registered in the United States and/or other countries.
Need help?
Do you have a question about the PAC200T and is the answer not in the manual?
Questions and answers