Page 1
ASSEMBLY Camshelving Ultimate Sheet Pan Rack ® MANUAL IMPORTANT! DO NOT CUT tie straps until AFTER STOP! the bottom frame is installed. ¡ ALTO! IMPORTANTE! NO CORTAR las atuduras plasticas del panel hasta el marco inferior haya sido instalado. SCAN HERE to watch short assembly video.
Camshelving ® IMPORTANT! DO NOT CUT tie straps Ultimate Sheet Pan Rack until AFTER the bottom frame is installed. IMPORTANTE! NO CORTAR las atuduras plasticas del panel hasta el marco inferior Parts and Tools haya sido instalado. Post Connector Frame Wedges...
Page 3
Step 1: Install Bottom Frame IMPORTANT! DO NOT CUT tie straps until AFTER the bottom frame is installed. IMPORTANTE! NO CORTAR las atuduras plasticas del panel hasta el marco inferior haya sido instalado. Remove Red Up Arrow Stick er from outside of each post. Place Bottom Post Connector Frame up onto posts, with frame clips facing down.
Page 4
Step 2: Install Top Frame CUT tie straps x (8). Move each rail panel down, starting at the bottom. Push next panel down, then in to engage with outside rim on lower panel. Install wedges as shown. Place Top Post Connector Frame onto wedges.
Step 3: Install Casters For Zinc Plated Casters For Premium Plastic Casters Lay rack down on 1 end. Lay rack down on 1 end. It is not necessary to remove small It is not necessary to remove small rubber band around plastic parts rubber band around plastic parts on caster stem.
Need help?
Do you have a question about the Camshelving and is the answer not in the manual?
Questions and answers