Advertisement
Connecting
Surface fastening
Pulsed signal 3
CR (common)
Transmitter
power supply
+ 12 Vdc
- 0 V
You must connect the 0V of the transmitter to the 0V of the converter. It is
NOTE
recommended that you use a shielded cable (with the grid connected to the
grounding wire) for cables that go to the converter (current and 0V outputs).
Configuration
hole
The transmitters are generally configured at the factory. However,
it is possible to make consultations or configurations by using
a "Module Reader," consisting of a screen and four keys that are
connected to the transmitter through the only visible connector
inside.
Press the
-
With the - and
the menu. With the
option. With the c c key, the previous hierarchy.
Within the main menu, you can see the following options:
• Consultation
• Configuration
Surface
fastening hole
key to enter the main menu.
+
+ keys, you can change the options within
key, you can enter the selected menu
c c
User manual |4-20 mA Pulsed Signal TransmitterA ·
Pulsed signal 1
CR (common)
Pulsed signal 2
1, 2, and 3
current outputs
3
Advertisement
