Do you have a question about the SRO8321 and is the answer not in the manual?
Questions and answers
Angela knowles
May 26, 2025
in induction cooker doesn't indicate whether a function has been selected and I am never sure if the correct function is on
1 comments:
Mr. Anderson
May 27, 2025
After pressing the “ON/STANDBY” button, press the “Function” button to enter heating mode. The induction cooker will only heat if the correct function is selected and a proper pot is placed on the ceramic plate. If no function is selected within 10 seconds, the cooker switches off automatically. If a proper pot is not detected, an alarm sounds and the cooker switches off after one minute. This indicates whether the correct function and setup are in place.
IMPORTANT SAFEGUARDS For safety reasons and to avoid damage to the appliance or injuries to people, please abide by all the safety instructions below. Ignoring safety warnings may result in injuries. This appliance does not take into consideration the following situations: - use by children or disabled people without supervision;...
Page 4
IMPORTANT SAFEGUARDS The utensils provided for the induction cooker can only be used for cooking with it. These cooking utensils cannot be used on both induction cooker and gas stove. To avoid injuries such as scalding, do not let children operate the appliance alone.
Page 5
IMPORTANT SAFEGUARDS To avoid damage, avoid causing impacts on the heating plate. If the surface is cracked, switch off the appliance to avoid the possibility of electric shock. When using the induction cooker, place it horizontally and allow at least 10cm of free space between the sides and back of the induction cooker and the wall.
Page 6
IMPORTANT SAFEGUARDS Please use a dedicated and high quality power outlet, with high power rating, equal to or above 10A. Do not use poor quality outlets. Do not share the power outlet with electrical appliances with high power ratings, such as air conditioners, electrical stoves etc.
Page 7
IMPORTANT SAFEGUARDS Always clean the induction cooker to prevent mess from getting into the fan, which could influence the normal operation of the appliance. When operating the appliance or after moving the pot, the cooking Danger of scalding area will remain hot for a period of time.
Page 8
IMPORTANT SAFEGUARDS Warning We suggest that you should periodically check that there are no object (glass, paper, etc.) that could obstruct the inlet under your induction cooker. Keep electrical appliance out of reach from children or inform person. Do not let them use the appliances without supervision.
Technical Data of the Product Model No. Rated voltage Rated power Dimension Weight 2000W 350X280X68 mm 2.8 kg SRO8321 220-240V~ 50/60Hz Product Fiche Symbol Value Unit Model SRO8321 Type of hob Freestanding Number of cooking zones and/or areas...
Page 10
Product Introduction Product Sketch Map Air vent Ceramic plate Power cord Cooking zone indicator Temp. Level Control panel Air entry Control Panel Temp. Level Timer Keep warm ON/STANDBY Boost Lock Function...
Product Introduction Before using New Induction cooker ● Read this guide, taking special note of the "Safety Warnings" section. ● Remove any protective film that may still be on your ceramic plate. Using the Touch Controls ● The controls respond to touch, so you don't need to apply any pressure. ●...
Page 12
Operation Instructions Turn on ● After pressing the “ON/STANDBY” button, the induction cooker is ready for heating. Press the “Function” button, the induction cooker enters heating mode. ● After pressing the “ON/STANDBY” button, if no function button is pressed for 10 seconds, the induction cooker will switch off automatically.
Page 13
Operation Instructions Keep Warm ● Press the “Keep warm” button to maintain warmth. Under this mode, the induction cooker heats the ingredients with gentle power to maintain a certain temperature inside the pot. Note: Under this mode, the power cannot be adjusted. Boost ●...
Compatible Cookware Iron oil frying Stainless Iron pan Iron kettle steel por Enamel stainless Enamel cooking Iron plate steel kettle utensil ● Requirement for pot materials: containing magnetic inducting materials. ● Shape requirement: plat bottom, with the diameter more than 15 cm and less than 20 cm.
Cleaning And Maintenance ● For oil spots on the cooker plate, wipe the cooker plate by using a soft moist cloth with a little tooth paste or mild detergent. And then use a soft moist cloth to wipe it until no stain remains. ●...
Environmental protection Responsible Disposal At the end of its working life, do not throw this product out with your household rubbish. Electrical and electronic products contain substances that can have a detrimental effect on the environment and human health if disposed of inappropriately.
Page 17
Warranty We pride ourselves on producing a range of quality home appliances that are both packed with features and completely reliable. We are so confident in our products, we back them up with a 3 year warranty. Now you too can relax knowing that you are covered. Customer Helpline NZ: 0800 422 274 This Product is covered by 3 year warranty when accompanied by proof of purchase.
Need help?
Do you have a question about the SRO8321 and is the answer not in the manual?
Questions and answers
in induction cooker doesn't indicate whether a function has been selected and I am never sure if the correct function is on
After pressing the “ON/STANDBY” button, press the “Function” button to enter heating mode. The induction cooker will only heat if the correct function is selected and a proper pot is placed on the ceramic plate. If no function is selected within 10 seconds, the cooker switches off automatically. If a proper pot is not detected, an alarm sounds and the cooker switches off after one minute. This indicates whether the correct function and setup are in place.
This answer is automatically generated