SAFE FIRE DETECTION ProLocator Fire Sniffer PI6198600 Operator's Manual

OPERATOR'S MANUAL
Handheld
Portable
Air
Sampling Detector
GENERAL SAFETY RULES
1
ACAUTION:
Gal
Y
read through this entire manual before using Your
A D O not overreach when operating the ProLocator's handheld probe.
new PmLocator Fire Snifferw.
AKeep proper footing and balance.
APemonal Safety: Stay alert, wa!h what You are doing and usecommon
AUse only accessories that are recommended by the manufacturer.
sense when operatlng the Flre ~nlffe?'.
AService must be performed only by SAFE Fire Detection Inc.
A D O not operate unit in areas with heavy smoke concentrations.
A D O not operate unit while standing in water.
ACharge the battery only with the specified charger for the battery.
I
FEATURI
The ProLocator Fire snifferTMis the industry's first handheld portable air sampling detector. Belonging to the Proseries family, the Fire
Snifferwuses CCDTMtechnology to provide Very Early Warning Fire Detection (VEWFD) to identify the source and can bke you within
one foot of an invisible and odorless fire in a 20,000 sq. ft room. The Fire Snifferwfeatures adjustable sensitivity levels that can guide you
in the right direction. Because it uses CCDwyou don't have to worry about the Fire Snifferwgiving you false information; it is immune to
dust dirt, heat, cold, humidity and other factors that could deter it from leading you to the right location.
1
-
ProLocator Fire SnifferTM
2
-Power Switch
3
-
PowerIFault Lights
4
-
LCD Display
5
-
Level
LEDs
6
-
Sensitivity Adjustment Button
7
-
Air Intake Port
8
-
Handheld Probe (Optional)
%\,
Model PI6198600
4
' .
SPECIFICATIONS
I
Weight:
1
w r
.
.WI."L. I.
h","
Unit Operating Tern
HumMity:
Handheld
Pmbe
Location lndimb
Carrying Case
I
OPERATION
I
&FORE U@Mg YOUR YOUR
P -
@ b m
(%HAR61N"QS
THE
BATTEN)
Make sure tbte unft is turned off while charging.
This unit has been shipped in a low charge condition to prevent possible
probtems. Therefore, you should charge the internal batteries prior to your
initial use.
Connect battery charger to Prolocator, then connect battery charger to
110 Volt AC wall outlet. Only use approved battery charger
(Part Number PL6198600P16).
Battery charger will indicate red when charging.
Batteries are fully charged when indicator is green.
Disconnect AC 110 Volt plug from wall outlet.
m
Disconneci battery charger from ProLocator.
PREPARING THE
m -
Press the h w e r Switch.
The power tight will illuminate green.
After one minute if the fault light does not illuminate, the ProLocator is
ready for use.
If the FAULT LIGHT illuminates and remains illuminated for more than
hnro
minutes or no text is displayed on the LCD display, contact technical
assistance at SAFE Fire Detection Inc. (704) 821-7920.