Advertisement
Quick Links
*Check all screw tightness periodically , and tighten if needed
Stanwood
®
Step 1
Gather these parts, one pole with beveled edge, three sup-
port stakes from the box .
Step 2
Hammer the main pole into the
ground using a Rubber Mallet until
the black line touches the ground
(about 1 ft.
deep).
Step 5
Slide a third support stake on to the main pole. Position it
evenly away from the first two stakes and hammer it into the
ground.
* We recommend you use
Tumbling Flower Spinner Assembly Instruction
Installation: Pole Anchoring
Step 3
Slide a support stake into
the main pole
and hammer it into the
Step 4
Slide a second support stake into the main
pole. Position it ~120
the first stake and hammer it into the
ground.
blue
Loctite thread locker if in windy area
Copyright © Stanwood Imports & Oriental Touch LLC
0
degrees away from
Connect the three pole
sections together.
1
Advertisement
Summary of Contents for Stanwood Tumbling Flower Spinner
- Page 1 Connect the three pole evenly away from the first two stakes and hammer it into the sections together. ground. * We recommend you use blue Loctite thread locker if in windy area Copyright © Stanwood Imports & Oriental Touch LLC...
- Page 2 Repeat on the other wheel Pay close attention to numbering “6” and “9 ” on the stem, do not mismatch. * We recommend you use blue Loctite thread locker if in windy area Copyright © Stanwood Imports & Oriental Touch LLC...
- Page 3 *Check all screw tightness periodically , and tighten if needed Step 7 cont. Step 8 Place the assembled Screw on the mushroom caps wheel with the Finished wheel assembly numbering facing inside towards the brass T-Bar. Repeat on the other side Step 9 Step 10 Slide the brass T-bar onto the pole...
Need help?
Do you have a question about the Tumbling Flower Spinner and is the answer not in the manual?
Questions and answers