OzBlinds Venetian Series Installation

ALUMINIUM BLIND
I N S T A L L A T I O N
Mounting Brackets
IMPORTANT NOTES:
1. Please check that all parts have been supplied before you begin to assemble your new
Custom Venetian Blind.
2. Ensure that the blind is mounted level for correct operation.
To the wall or front of the window frame
To the ceiling or top of the window frame
To Operate The Blind
Important – always tilt the slats horizontally before raising or lowering the blind.
This will extend the life of the blind, and makes the movement easier and smoother.
Raising: Pull the cord downward until the blind reaches the desired height; release the cord, and the blind will lock automatically.
Lowering: Hold the cord at eye level and move it to the left, pulling down gently until the cord lock releases. Allow the cord to pass through
until the blind reaches the desired level. Move the cord to the right and release, and the blind will lock automatically.
Tilting: Rotate the wand on the blind in either direction to attain desired slat position
Blinds must be fitted with safety devices provided to comply with legal requirements. Please turn over
PARTS INCLUDED
Hold Down Bracket Installation
Screws
1. Position the end brackets for fixing (either face or top) ensuring that the
brackets are fixed approximately 50mm from the end of the blind.
The centre bracket (required for blinds exceeding 1200mm width) may
be positioned as required.
NB: Make sure not to position the brackets where they would interfere
with the working mechanisms of the blind.
2. Position the front edge of the track into the front hooks of the
installation bracket and gently push upwards and the track will
"snap" into position.
WARNING!
leaflet for instructions to fit safety devices.
Cord Cleat Cord Cleat
Screws (compulsory)
Safety Cord Stop
(supplied on cord)