Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for THERMOSTAHL Airvent Series
- Page 1 HOT AIR WOOD STOVE AIRVENT TECHNICAL DOCUMENTATION V. 1.1...
-
Page 2: Table Of Contents
Index TEHCNICAL CHARACTERISTICS ................3 GENERAL DESCRIPTION ..................3 SAFETY DIRECTIONS ..................... 4 INSTALLATION DIRECTIONS ................... 4 Electrical diagram ....................4 USE DIRECTIONS ....................5 General directions ..................... 5 Use of control panel ................... 5 CLEANING AND MAINTENACE .................. 8... -
Page 3: Tehcnical Characteristics
1 TEHCNICAL CHARACTERISTICS The Airvent hot air wood stove has advanced design and best quality of construction. It is equipped with fireproof glass. The hot air is delivered by the frontal and lateral blinds of the stove. Main advantages are high efficiency, quick response to heat demand, digital control, and low cost of operation. -
Page 4: Safety Directions
3 SAFETY DIRECTIONS This device shall not be used by people with lower physical or mental abilities, children, or people without experience. Children should always be supervised not to touch the device. There are hot surfaces that might cause injury! It is recommended not to install the stove on floor made of flammable material. -
Page 5: Use Directions
Electrical data Voltage 230V ± 10% - 50Hz Protection Internal fuse Sensor temperature C÷250 Output Fan 230V – 200W max. Dimensions Inserted 120 x 80 x 50 (mm) Norms complying EN60730-1 50081-1 EN60730-1 A1 50081-2 5 USE DIRECTIONS General directions Before you put the stove in function check the following: ... - Page 6 In PROP mode, the fan speed modulates according to the sensor temperature; the higher the temperature, the higher the fan speed. If you want to change some parameters (activation temperature, min/max fan speed etc.) you can enter the control panel menu. ON/OFF function Keep pressed the P1 button for ON/OFF function.
- Page 7 Alarm or Error signals Lo=low temperature (temperature below 0 C: sensor not connected) Hi=high temperature (temperature higher than 180 C: sensor short-circuited) ATTENTION: The sensor cable is designed for temperature until 250 C. It must not come in contact with metallic parts of the stove that have a temperature higher than 250 All electrical connections of the device must be executed by an experienced professional.
-
Page 8: Cleaning And Maintenace
6 CLEANING AND MAINTENACE Once a year it is necessary to clean the stove and the chimney from the ash and dust remains. When you clean the stove have the ash drawer closed. Clean the door glass with a wet cloth or mild cleaners. Do not use active substances. Clean the exterior painted surfaces of the stove with a wet cloth, and not with drastic liquids. - Page 9 THERMOSTAHL ROMÂNIA SISTEME TERMICE S.R.L. DRUMUL OSIEI 57-59, sector 6 Bucureşti 062395, România Tel: 021 352 55 22; 021 352 55 23 Fax: 021 352 55 24...
Need help?
Do you have a question about the Airvent Series and is the answer not in the manual?
Questions and answers