Corbin H-FURY-FLIP Quick Start Manual

Part Number:
Description:
Rumble Seat
Fitment:
2010 Honda Fury
Revision:
1
Tools Required
10mm Socket Wrench
7/16" Open Wrench
Needle nose Pliers
1. Remove your stock seat. Refer to your
owner's manual if necessary.
2. To install the seat without heater unit, install
the latch pin and latch pin cup on the rear fender,
using a 7/16 open wrench (Figure 1), then slide
the nose of the seat into position and lower the
seat onto the latch pin until you hear (and feel) it
"Click".
Heater Installation:
1. If you ordered the heated model, we also
included a wiring harness and fuse adapter that
hooks into your stock fuse box, so start by
removing your right side cover to gain access to
the fuse box.
2. Unbolt the stock ground wire, using a 10mm
socket wrench (Figure 2). Route the ground wire
on the supplied wiring harness under the frame
and place it onto the stock ground wire and
secure with the stock bolt (Figure 3).
3. Locate the fuse box and remove the 10amp
clock fuse position (Figure 4), using needle nose
pliers (Figure 5) and insert the fuse into the
supplied adapter at the end of the wiring harness
(Figure 6), then Insert the adapter into the fuse
box into the space previously occupied by the 10
amp clock fuse (Figure 7).
H-FURY-FLIP(E)
1 SP00362, SWH-CB-HL Wiring Harness / pigtail
3 4" zip ties
1 SP00351, #FACC-05 Small Fuse Adapter
1 SP00354 Fuse
1 Large Fuse box rain cover
Parts List
FIG 1
FIG 2
FIG 4
1 #P00676 Latch pin
1 #P00545 Latch pin cup
FIG 3
FIG 5