Gliderol TM-27 Instructions

TM-27 Single Button Handset
Programming New or Additional Handsets
The following instructions demonstrate how to program a new or additional Gliderol Single Button
Handset to suit most Gliderol operators pre-1998. Older Gliderol units operate using either Trinary or
Binary coding. Trinary units will have a 9 digit code shown inside the operator Control Box, whereas
Binary units will have two 8 digit codes inside their Control Box. Please refer to the appropriate set of
instructions to successfully program your new Gliderol Single Button Handset.

Trinary Handset Coding - 9 digit code

Step 1:
REMOVE
COVER
Remove the cover from the handset to expose
the handset circuit board.
Your handset programming
is now complete!
Should you require further assistance
in programming your Gliderol Single Button
Handset please contact your local
Gliderol office on 1300 799 177.
Step 2:
CODE
SWITCHES
Push the numbered switches 'up' or 'down' to
reflect the same code shown inside your existing
control box.
www.gliderol.com.au