PROGRAMMING INSTRUCTIONS Holiday Mode: The holiday mode is used to suspend the regeneration of the unit during extended periods on non water usage, The Holiday mode is deactivated when a flow rate through the unit of greater that 1.5 gallons per minute is reached or when it is deactivated by pressing the: SCROLL BUTTON...
Page 3
SCROLL BUTTON SCROLL BUTTON The numbers displayed may vary SCROLL BUTTON depending on the model and pervious programming and the time of day. The control will display: Delayed Regeneration: The display should read: The numbers displayed may vary depending on the model and pervious programming and the time of day The numbers displayed may vary depending on the model and pervious...
Page 4
UP BUTTON again moves Time Regeneration b elow . DOWN BUTTON 3b. Variable Reserve: to change the value of this setting. Press the: The variable reserve is automatically set at SCROLL BUTTON 25% of capacity + 75 gallons. This feature automatically monitors the water used and to move to the next setting.
DOWN BUTTON 7. Brine and Rinse: to change the maximum number of days The display should read: between regenerations. Setting to off disables " " " " this feature. Pressing the: The number displayed may vary depending SCROLL BUTTON on the model and pervious programming. again moves you the next setting This mode may not be available under certain conditions...
to return to the service mode and burn in the again moves you the next setting new settings. 9. Exit: If you want to return to the previous settings The display should read: wait for one minute without touching the control panel and the valve will revert automatically.
Page 7
Last Regeneration: Note: Not applicable on all models. Displays the amount of water used before the Units: last regeneration. Displays mode measurement, Peak Flow: ENGLISH or METRIC. Displays the peak flow rate since the last Meter: regeneration.. Displays whether the control is programmed Note: This function resets back to zero after as STANDARD METER, NO METER or every regeneration.
Page 8
Typical Drain Fitting (not included) Drain Connection: Drainpipe should be 1/2" Hose larger terminated in a manner that acceptable local codes. Brine Connection: Plastic hose from the brine To Softener tank connects here. Insert hose into connector to the depth of the nut and hand tighten.