Advertisement
Quick Links
These instructions are for the installation of our TRX-4 – Ascender Blazer body mount system. This will
allow you to mount an Ascender K5 Blazer body directly to your Traxxas TRX4 with minimal (if any)
modification to your TRX4. These instructions were created using a "Land Rover" TRX4 setup. You can
use the Bronco chassis & wheel wells but will need to sand for headlight buckets.
1. Remove font body mount posts.
Advertisement
Summary of Contents for Locked Up RC TRX-4
- Page 1 These instructions are for the installation of our TRX-4 – Ascender Blazer body mount system. This will allow you to mount an Ascender K5 Blazer body directly to your Traxxas TRX4 with minimal (if any) modification to your TRX4. These instructions were created using a “Land Rover” TRX4 setup. You can use the Bronco chassis &...
- Page 2 2. Remove front body mount post support. 3. Install new front body mount post support.
- Page 3 4. Install original Body mount posts into new body mount post support. 5. Remove rear body mount posts.
- Page 4 6. Install new rear body mount posts. 7. Body clip pin studs should be offset to the rear.
- Page 5 8. Adjust body mount posts to suit your desired height, keeping body level. For the front we recommend this to start: For the rear we recommend this to start:...
-
Page 6: Troubleshooting
Land Rover body. Issue: The body is where I want it but the TRX-4 sliders sit too low. Solution: Space the TRX-4 sliders up using longer M3 hardware and spacers.