HySecurity MX3426 Installation Instructions

StrongArm Flashing Light Kit
• MX3425 LED Light Bulb (24V, AC/DC) for electric flasher kits
• MX3426 Light Kit, Flashing, runs on 24VDC
• MX001197 Add-On Light Kit, Flashing runs on 24VDC
NOTE: The Add-ON Light Kit has its own separate set of instructions.
Tools Needed:
• 7/16" socket head wrench
• 3/8" drive rachet
• Flat head screwdriver
• Needle nose pliers
• Wire nuts
DANGER
Turn off power to the Control Box before
installing the Light Kit.
Installation Steps
Review the illustrations and follow
the steps below:
1. Open the package and unwind
the length of cable.
NOTE: Fourteen feet (4.2 m) of cable
accompanies the MX3426 Light Kit.
continued...,
Loop required
for barrier arm
movement. Allow a
minimum 2 foot (61 cm)
cable slack.
24VDC N.O. (Normally Open)
Wire connection: Solid state, user relay 3
Installer Menu: Set Relay Logic, RL 3 to "19"
www.SecureOpeners.com | (800) 878-7829 | Sales@SecureOpeners.com
Installation Instructions
CAUTION
Order MX3425 LED replacement bulbs for use in the light kits. DO NOT use incandescent
bulbs. Incandescent bulbs draw a disproportionate amount of amperage and, if used,
voids the Limited Warranty and may damage the equipment.
If using the "Add On" kit MX001197, connect wires together in parallel.
StrongArm Flashing Light Kit
MX3426
Red Lens
Amber Lens
Fasteners:
Bolt: ¼" x 20 x 1¾"
2 washers
1 lock nut
Barrier Arm
Barrier Arm