Packing List - Scotts LCS31440S Owner's Manual

UNPACKING
This product requires NO assembly.
Carefully remove the product and any accessories from the box.
Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call 1-800-618-7474
for assistance.
TO INSTALL/REMOVE BATTERY PACK
Scotts
This product will accept
For complete charging instructions, refer to the Owner's Manual for
your battery pack and charger models.
To install battery pack:
■ Align grooves on battery pack with raised ribs in the tool's battery
port and place the battery pack in the tool.
WARNING: Make sure battery pack is fully seated and secure in the
battery port before beginning operation. Failure to securely seat the
battery pack could cause the battery pack to fall out, resulting in
serious personal injury.
To remove battery pack (Fig. 1):
■ Release the trigger to stop the chain saw.
■
Lift the battery release latch on the battery pack..
■
Pull the battery pack from chain saw.
HOLDING THE CHAIN SAW (Fig 2)
Always hold the chain saw with your right hand on the rear handle
and your left hand on the front handle. Grip both handles with the
thumbs and fingers encircling the handles. Ensure that your left
hand is holding the front handle so that your thumb is underneath.
NOTE: REMOVE BATTERY PACK FROM UNIT. FILL OIL TANK
WITH BAR AND CHAIN LUBRICANT (NOT PROVIDED)
BEFORE STARTING THE CHAIN SAW. FAILURE TO
LUBRICATE THE CHAIN WILL CAUSE DAMAGE TO THE BAR
AND CHAIN.
STARTING THE CHAIN SAW (Fig 3)
1. Before starting, you should install the battery pack in the
machine, and make sure chain brake is in run position by pulling
chain brake lever / hand guard toward the front handle.
2. To start the machine: press the trigger release button, and then
press the trigger.
CHECKING AND OPERATING CHAIN BRAKE
1. Engage the chain brake by rotating your left hand around the
front handle. Allow the back of your hand to push the chain brake
lever/hand guard toward the bar while the chain is rotating rapidly.
Be sure to maintain both hands on the saw handles at all times.
2. Reset the chain brake back into the Run position by grasping
the top of the chain brake lever / hand guard and pulling toward
the front handle until you hear a click.
40V lithium battery packs only.
®
Model LCS31440S
ASSEMBLY
WARNING: If any parts are damaged or missing, do not
operate this product until the parts are replaced. Failure to
heed this warning could result in serious personal injury.

PACKING LIST


Chain Saw with bar and chain assembled

Bar Cover

Charger and Battery Pack

Owner's Manual
Fig.1
Battery port
WARNING: Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning, carrying,
transporting or when not in use. Removing battery pack will
prevent accidental starting that could cause serious personal injury.
NOTE: To avoid serious personal injury, always remove the battery
pack and keep hands clear of the trigger release button when
carrying or transporting the tool.
OPERATING
6
Battery release
latch
Fig.2
Fig.3