Do you have a question about the INTERNATIONAL SPEEDWAY CAR CAROUSEL and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Jolly Roger INTERNATIONAL SPEEDWAY CAR CAROUSEL
Page 1
INTERNATIONAL SPEEDWAY CAR CAROUSEL HANDBOOK September 2010...
Page 2
JOLLY ROGER (Amusement Rides) Ltd. JOLLY ROGER (Amusement Rides) Ltd reserves the right to make changes, for the purpose of product improvement, at any time.
JOLLY ROGER AMUSEMENT RIDES CONTENTS INTRODUCTION WARNINGS AND CAUTIONS Health and safety - code of safe practice at fairs - Industry Standards (UNITED KINGDOM) INSTALLATION Siting OPERATION General MAINTENANCE General Multi power supply unit Coin acceptor (mechanical) Coin acceptor (electronic) MARS Electronic coin mechanism MARS - switch positions Stamar “Plug n Play Kiddie ride controller credit programming instructions...
Page 4
JOLLY ROGER AMUSEMENT RIDES INTRODUCTION Thank you for purchasing your new Kiddie Ride from Jolly Roger (Amusement Rides) Limited and we trust it will give many years of trouble-free profitable service. Whilst this booklet has been produced primarily with our United Kingdom and European customers in mind, it will certainly be of benefit to other users worldwide.
Page 5
JOLLY ROGER AMUSEMENT RIDES HEALTH AND SAFETY - CODE OF SAFE PRACTICE AT FAIRS - INDUSTRY STANDARDS (UNITED KINGDOM) Our equipment has been manufactured to the highest standard of construction and safety in order to conform to the H.S.E. Fairground and Amusement Parks, A Code of Safe Practice and the U.K. Health and Safety at Work Act 1974.
Page 6
JOLLY ROGER AMUSEMENT RIDES INSTALLATION Siting IT IS NOT RECOMMENDED THAT THE RIDE BE SITED ON A PLINTH, PLATFORM OR ANY FORM OF MATTING. DOING THIS WILL INCREASE THE HEIGHT OF THE RIDE FROM THE GROUND AND MAY CAUSE INJURY FROM FALLING OR TRIPPING.
Page 7
JOLLY ROGER AMUSEMENT RIDES INSTALLATION Site d’installation ATTENTION IL N’EST PAS RECOMMANDE DE CONDUIRE SUR UNE PENTE, RAMPE OU AUTRE AFIN DE NE PAS ELEVER LA HAUTEUR DU VEHICULE ET NE PAS CAUSER DE BLESSURES EN RAISON DE RENVERSEMENT OU D’ACCROCHAGE.
Page 8
JOLLY ROGER AMUSEMENT RIDES OPERATION General A coin-operated Kiddie Ride should not be used unless a D.O.C. has been provided, indicating that the device is safe to operate (UK Health and Safety at Work Act - Code of Safe Practice at Fairs). This regulation applies in the UK only.
JOLLY ROGER AMUSEMENT RIDES MAINTENANCE GENERAL The rides do not require any periodic maintenance but, they should be checked regularly to ensure that they are in a safe condition for operation by the general public. In the unlikely event of the need to make adjustments or repairs to the machine, the following procedures are recommended.
JOLLY ROGER AMUSEMENT RIDES Coin acceptor (electronic) MARS To remove/refit the coin acceptor proceed as follows: 4.4.1 Remove the coin acceptor by turning the lock situated on the faceplate and disconnect the cable plug from the printed circuit board on the mechanism - the coin acceptor can now be removed from the machine.
JOLLY ROGER AMUSEMENT RIDES Stamar “Plug n Play” Kiddie Ride Controller Credit Programming Instructions The “Plug n Play” Timer Unit can now be programmed “on-site” for any Credit functions as shown by the following instructions. This facility is incorporated on all software from JRTDv4 onwards...
Page 12
JOLLY ROGER AMUSEMENT RIDES Stamar “Plug n Play” Kiddie Ride Controller Configuration Instructions The new “Plug n Play” programmable control unit has four externally accessible DIL switches, SW1, SW2, SW3 and SW4, which are used to select the most popular modes of operation.
Page 13
JOLLY ROGER AMUSEMENT RIDES SW1 sets the Price of Play value or Credit Program Options. The SW1 switch is used to set price at play value or credit program options. NOTES 1. The setting for either “price of play” or “credits” on SW1 as shown below are selected using SW3/S4 as shown in SW3 settings below.
Page 14
JOLLY ROGER AMUSEMENT RIDES Ride time 4.10 SW2 is used to set the ride time. The ride time can be set from 30 seconds to 120 seconds in 15 second increments or to run for as long as the main background soundtrack.
Page 15
S4 is used to select “Program Mode” and under normal operating conditions is not to be used and must be set to the OFF position. “Program Mode” should only be used by experienced operators familiar with the extended programming sequence, or under direct instruction from Jolly Roger (Amusement Rides) Ltd., or Stamar Electronics.
Page 16
JOLLY ROGER AMUSEMENT RIDES Fuses 4.19 Fuses are located in the side of the multi PSU. Never replace fuses with a higher value than recommended. Body and other mouldings 4.20 Clean with damp cloth rinsed out in soapy water, do not hose down or flood the machine. Alternatively, a proprietary household furniture cleaner may be used.
Page 17
JOLLY ROGER AMUSEMENT RIDES 4.23.6 Ensure the area around the ride is free from obstruction and that persons passing by are not in any danger. 4.23.7 The ride should be kept clean and free from any customised additions unless approved by the manufacturer.
JOLLY ROGER AMUSEMENT RIDES Fig 4 Wiring diagram cash box - Base to body loom connector (System 4000) Page 18...
Page 21
Foreign orders must be sent through our accredited agent, an established London House, or accompanied by a remittance. Replacement parts which are not of genuine Jolly Roger supply, cannot be relied upon to be to the correct specification, material or workmanship. Jolly Roger therefore cannot be expected to extend their Warranty to Kiddies Rides which have been fitted with parts which Jolly Roger has not supplied.
JOLLY ROGER AMUSEMENT RIDES Fig 7 Body Shell Assembly Page 26...
Page 29
JOLLY ROGER AMUSEMENT RIDES s t r s i l t n I o i t † e t I u l l e t I o i t † s t l † † † † c i t †...
Page 30
JOLLY ROGER AMUSEMENT RIDES THIS PAGE NOT USED...
Page 31
Earth bonding and dielectric strength. The rides have also been tested and comply with requirements of FCC Part 15, Class A. THIS CERTIFICATE DOES NOT EXONERATE THE OPERATOR FROM REGULAR CHECKING AND MAINTENANCE OF THE MACHINE TO WHICH IT APPLIES. Jolly Roger (Amusement Rides) Ltd. Heath Road, Skegness Industrial Estate, Skegness,...
Page 32
JOLLY ROGER AMUSEMENT RIDES THIS PAGE NOT USED Annex A...
Page 33
JOLLY ROGER AMUSEMENT RIDES Jolly Roger (Amusement Rides) Ltd. Heath Road, Skegness Industrial Estate, Skegness, Lincolnshire, Telephone: + 44 (0)1754 896800 PE25 3SU Fax: + 44 (0)1754 610066 England. E-mail: sales@jolly-roger.co.u k EC DECLARATION OF CONFORMITY (Revised 1st January 1997 and 1st September 2002)
Page 34
JOLLY ROGER AMUSEMENT RIDES THIS PAGE NOT USED Annex B...
Need help?
Do you have a question about the INTERNATIONAL SPEEDWAY CAR CAROUSEL and is the answer not in the manual?
Questions and answers