Summary of Contents for United CoolAir EZ-Fit Cart
- Page 1 EZ-Fit Cart Manual 491 East Princess Street P.O. Box 2423 York, Pennsylvania 17405-2423 (717) 843-4311 Fax (717) 854-4462 www.unitedcoolair.com Email: uca@unitedcoolair.com I. Cart Assembly Items...
- Page 2 a. 2 Allen Wrenches (3/16 left and 5/32 right) b. 1 Tote Bag c. 3 Rubber Straps d. 2 EZ-Fit Drawings e. 4 Vertical Upright Rails...
- Page 3 f. 4 Horizontal Width Rails g. 2 Horizontal Bottom Length Rails with Casters h. 2 Horizontal Top Length Rails...
- Page 4 II. Cart Assembly (Using 5/32 Allen wrench) a. When connecting the pieces make sure the black hardware washer is in the slot of the connecting piece before tightening. Don’t use the head of the bolt to secure the pieces, the two pieces will not pull together flush.
- Page 5 b. Attach Vertical Upright to Horizontal with Caster c. Attach Vertical Upright to other end of Horizontal Caster...
- Page 6 d. Attach Horizontal width piece to Upright attached to Horizontal Caster i. Put the caster base is the same direction as width piece ii. White vinyl is inward iii. Top center piece must point upward e. Repeat step e for other end...
- Page 7 f. Connect Vertical Upright rails to other horizontal Width rail g. Repeat step f for other horizontal width rail h. Attach other Horizontal Length with Casters to the Upright rails installed in steps f & g...
- Page 8 i. Set Cart upright on the casters. Confirm all caster mounts and white vinyl are inside the frame j. Attach remaining 4 Horizontal pieces to the uprights...
- Page 9 III. Adjusting the Dimensions of the Frame a. Use ONLY the 3/16 Allen Wrench b. Loosen (DO NOT REMOVE) the 4 Cap Bolts per rail assembly on all Horizontal frame pieces that coincide with the dimension which is being lengthened or shortened...
- Page 10 c. Remove all pins from Horizontal frame pieces which are being adjusted d. Either lengthen or shorten the frame rails...
- Page 11 e. Line up the end of the top rail of the rail assembly with corresponding colored lines and insert PIN in hole between the Cap Bolts f. Repeat for other end of rail assembly g. Repeat step e & f for all other rail assemblies being adjusted...
- Page 12 h. Tighten 4 Cap Bolts per assembly for all 4 rail assemblies PACKING CART FOR SHIPMENT a. Disassemble the cart using the 5/32 Allen wrench (DO NOT REMOVE THE BOLTS)…..ONLY LOOSEN b. Place 3 rubber bungee cords on flat surface with hooks facing upwards c.
- Page 13 f. Repeat step f for remaining 2 horizontal short rails and 2 vertical rails g. Place the 2 interconnected pieces assembled in steps f/g on top of the 4 horizontal long rails h. Wrap with bungee straps...
- Page 14 i. Place cart assembly in tote bag j. Place Allen wrenches in total bag pocket k. Place drawings in tote bag with cart l. Zip closed the bag and snap/tighten the red straps...