Page 1
BMW Motorrad Navigator III owner's manual Teile und Zubehör...
Page 2
Information in this document is subject to change without notice. BMW Motorrad reserves the right to change or improve its products and to make changes in the content without obligation to notify any person or organization of such changes or improvements. Updates and further information on the application and use of this product can be found at the BMW Motorrad Web site.
Page 3
For use in or on other vehicles, it is the sole responsibility of the owner/operator of the BMW Motorrad Navigator III to place and secure the unit so that it does not interfere with vehicle operating controls or obstruct the driver’s view of the road (see diagram).
Serial Number Record the serial number (8-digit number located on the back of the unit) in case your Navigator III needs service or you would like to buy additional maps. __ __ __ __ __ __ __ __ Navigator III Owner’s Manual...
SPEAK announces voice directions. Press ➍ and hold to adjust the volume. Power cable connector Back of Navigator III (out of Mount) IN/OUT zooms in and out of the map, ➎ selects buttons and options. Press and hold to scroll through multi-page lists.
As soon as you turn on the Navigator III, it begins acquiring GPS satellite signals. The first time you acquire satellites, it may take a few minutes. Stop your vehicle and position the Navigator III where it has a clear view of the sky. The bars in the upper-left corner the bars to view more information about the GPS signals.
Following Your Route As you travel to your destination, your Navigator III guides you to your destination with voice prompts, arrows, and directions along the top of the map. If you depart from the original route, your Navigator III recalculates the route and provides new route instructions.
Home—creates a route to your home location. To set your home location, see page Search Results Your Navigator III sorts the search results list by distance from your current location; the closest locations are listed first. Finding Locations in a Different Area 1.
5. If necessary, enter the rest of the address, and.touch.Done.. 6. Select the address, if necessary. Touch.Go To.. TIP: Searching for a city, street, intersection, or exit is very similar to Code. searching for an address. Touch > Streets & Cities. Navigator III Owner’s Manual Where To...
Navigator III Owner’s Manual Saving Your Current Location View Map. You can also press the Touch MAP key on the front of the Navigator III. 1. Touch anywhere on the map. Touch.Save As Favorite to save your current.location.. Setting a Home Location Touch.Where To.>.Go...
Navigator III owners using Bluetooth technology. First, give the Navigator IIIs unique Settings Bluetooth friendly names. Touch > Friendly Name. Touch.Tools.>.My Data.>.Favorites>. Transfer Favorites using Bluetooth.. Your Navigator III will look for other Bluetooth devices. Navigator III Owner’s Manual >...
Favorites. Saving Coordinates If you know the exact geographic coordinates of your travel destination, you can use your Navigator III to navigate to any location using its latitude and longitude coordinates. Touch.Where To.>.My Locations.>. Coordinates >.Enter Position..
MAP key repeatedly. Or, from the Main menu, touch Tools > Trip Computer. Distance to your Speed final destination Odometer Direction Touch Reset Trip to reset all information on the Trip Computer. To reset the maximum speed, touch Reset Max. Navigator III Owner’s Manual...
The sky view shows the satellites you are receiving. The satellite signal strength bars indicate the strength of each satellite signal. A solid bar indicates your Navigator III has a strong fix on that GPS satellite, and the GPS satellite is ready for use. For more information about GPS, see www.garmin.com/aboutGPS.
> Routes. TIP: Press and hold the MENU key to open the Routes > ➋ Touch an option, and touch Next.. Select.the.start.point. ➎ Select.sort.and.route.calculation. preferences, and touch Next. ➌ Touch an option, and touch Next.. Select.the.end.point. ➏ .Touch.Finish. Navigator III Owner’s Manual...
Deleting All Saved Routes Touch Tools > My Data > Routes > Delete All Saved Routes. Sharing Routes You can share routes with other Navigator III owners using Bluetooth technology. See Sharing Favorites on page 8 for more information. oUtes...
As you travel, the Navigator III creates a track log of your movement. Touch Tools > My Data > Track Log. Active Log—adjust the settings the Navigator III uses to record the track log. • Recording—turn off and on the track log recorder.
Hands-Free Phone Features After your devices with Bluetooth technology have been paired with the Navigator III, you can use the Navigator III to place and receive phone calls. From the Main menu, touch Phone. Use the Phone menu to place calls and review your call history.
Navigator III. This way, each change you make to your phone’s phone book is reflected the next time you use it with your Navigator III. NOTE: After your phone is paired with the Navigator III, it can take a...
Dial.. 2.. Speak.the.contact.you.want.to.call. NOTE: You may need to “train” your phone to recognize your voice commands. If so, the Navigator III will walk you through the process. Refer to your phone’s owner’s manual, if necessary. BMW Motorrad Navigator III Owner’s Manual...
Using an optional FM TMC (Traffic Message Channel) traffic receiver, you can view traffic on your Navigator III. For more information about the FM traffic receiver, participating FM traffic subscription providers, and covered cities, refer to www.garmin.com/traffic. NOTE: Garmin is not responsible for the accuracy of the traffic information.
Languages noted with “TTS” are text-to-speech (TTS) voices. The text-to-speech voices “read” and “speak” the words that are displayed on the Navigator III. The voices have an extensive vocabulary, and they pronounce the street names as you approach turns. The languages without “TTS”...
Garmin TourGuide Touch Settings > General > TourGuide. If you have a third-party, GPS-guided audio tour loaded on your Navigator III, you can select Auto Play to hear the complete tour as programmed, Prompted to show the speaker icon on the map when tour information is available during your route, or Off.
Navigator III. If you are navigating and comparing the GPS coordinates to a map, chart, or other reference, set the map datum in your Navigator III to the same datum as the map to ensure the most accurate navigation. Map Settings...
Continuous Auto Routing—turn on or off Continuous Auto Routing, which allows the Navigator III to continually search for a better route to your destination. This can be useful if a traffic accident occurs or there are time- restricted turns on the current route.
15–17 for more information. Bluetooth—turn on or off the Bluetooth technology. Friendly Name—enter a name for your Navigator III. This name is used when you are connecting to devices that have Bluetooth technology. Unit Information (About) Touch Settings > About. Touch an item to view information about it.
1. Use the security screwdriver to loosen the screw.on.the.top.of.the.cradle.lock.. 2.. Lift.the.cradle.lock.up.until.it.clicks.. 3. Pull the Navigator III out of the mount. 4.. Slide.the.power.plug.to.the.left.to. disconnect the power cable. Navigator III Owner’s Manual To install the Navigator III to the non-skid friction mount: 1..
About Detail Maps. menu. Touch > > To load maps to your Navigator III, see the MapSource Help file. Loading Extras Your Navigator III accepts custom points of interest (POI) databases, including Garmin TourGuide POIs available from various companies on the Internet. Some custom POI databases contain alert information for points, such as safety cameras and school zones.
To minimize the risk of damage to your Navigator III, avoid dropping your unit and operating it in high-shock and high-vibration environments. PPendix Do not store the unit where prolonged exposure...
PPendix Optional Remote Control Install two AAA batteries in the remote. Aim the remote toward the IR window on the front left of the Navigator III. (Zoom) In—zooms in on the map. (Zoom) Out—zooms out of the map. Menu—opens the Main ZOOM menu.
Part 15 regulations. Software License Agreement BY USING THE Navigator III, YOU AGREE TO BE BOUND BY THE TERMS AND CONDITIONS OF THE FOLLOWING SOFTWARE LICENSE AGREEMENT. PLEASE READ THIS AGREEMENT CAREFULLY.
How.do.I.clear all my user Turn off the Navigator III and then turn it back on. During start up, press and hold the FIND key on the front of the Navigator III. Keep data? holding.the.FIND key until the message “Do you really want to erase all user data?” appears. Touch I need to reset my Navigator original settings are restored.
Need help?
Do you have a question about the III and is the answer not in the manual?
Questions and answers