Advertisement
Stock No. 40-110
ProCabinet
Congratulations on your Bench Dog
ProCabinet purchase! Follow these
simple assembly instructions and you'll
be ready to support the heaviest router
tops on the market.
Note: Please read these instructions
completely before starting to assemble your
ProCabinet. Familiarity with the process will
make the steps easier to understand. Please
follow all steps carefully.
(28331)
™
RTD10000609AA
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Bench Dog Tools ProCabinet 40-110
- Page 1 (28331) Stock No. 40-110 ProCabinet ™ Congratulations on your Bench Dog Note: Please read these instructions ProCabinet purchase! Follow these completely before starting to assemble your simple assembly instructions and you’ll ProCabinet. Familiarity with the process will be ready to support the heaviest router make the steps easier to understand.
- Page 2 PARTS LIST Quantity Quantity 1 Shelf 18 Hex Wrench, 3/16" (Not Shown) 2 Drawer Divider 19 1/4-20 Cross Dowels 3 Bottom 20 Thread Lock (Not Shown) 4 Left Side Panel 21 Decal (Not Shown) 22 Washers 5 Right Side Panel (Not Shown) 6 Back Panel 23 Brushed Nickel handle...
- Page 3 Fig. 2 Fig. 1 1. Attach the Drawer Divider (2) to the Shelf (1), as shown in Fig. 1. Use two 1/4-20 x 2" round-head bolts (13) and two steel cross-dowels (19). Place a dab of thread-lock on the end of the bolts and tighten using the supplied 4mm Hex Wrench.
- Page 4 Fig. 6 Fig. 7 8. Place the Back Panel (6) onto the cabinet. Note the orientation of the dust port and cord cut-outs in Fig. 6. All steel cross-dowel holes are located inside the cabinet. Use ten 1/4-20 x 2" round head bolts (13) and ten steel cross dowels (19) to secure the panel.
- Page 5 Fig. 11 Fig. 12 15. Install the two Hinges (27) by pressing the cups into the pockets in the Door (11), and turning the integral cam fasteners. Fig. 11. Do not overtighten the cam. 16. Clip the Door (11) onto the cabinet. Fig.
- Page 6 Fig. 16 Fig. 17 23. Install the Dust Port (25) as shown in Fig. 16. Use four #6 x 1/2" pan head screws (13). Begin by drilling four 3/32" pilot holes through the port at the four corners. No pilot holes are necessary in the cabinet.
- Page 7 BENCH DOG DISCLAIMS AND BUYER EXPRESSLY WAIVES ANY AND ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO, IMPLIED CONDITIONS OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTABILITY, OR ANY OTHER MATTER. Rev 09/08 © 2008 Bench Dog Tools...
Need help?
Do you have a question about the ProCabinet 40-110 and is the answer not in the manual?
Questions and answers