Table of Contents
Advertisement
Quick Links
In addition to common hand tools, installation of this part will require the use of a body clip
tool or equivalent, T-25 & T-30 sockets, painters tape and isopropyl alcohol.
1. Raise the vehicle hood and disconnect the negative
terminal on the battery.
3. Remove the 5 plastic rivets in the core support cov-
er.
2019 Ford Ranger
RTR Upper Grille
Part numbers:
1992-7001-01 with Lighting Kit
1992-7003-01 with Non LED
Inserts
Components Included
1.
RTR Grille
2.
Grille Bezel
3.a
RTR Lighting kit
3.b
RTR Non LED Inserts
4.
Truss head Screws
5.
6" Cable Ties
6.
Grille Badge
NOTE: Does not fit Wildtrack Ranger
T-30 TORX
2. Using a T-30 Torx bit, remove the airbox inlet screws
and set them aside.
4. Pull upward forcefully on the core support cover to
unseat it from the retention clips. Slide the cover out
from underneath the airbox inlet and set it aside.
1
1
1
1
10
10
1
1
Advertisement
Table of Contents
Summary of Contents for RTR 1992-7001-01
- Page 1 2019 Ford Ranger RTR Upper Grille Part numbers: 1992-7001-01 with Lighting Kit 1992-7003-01 with Non LED Inserts Components Included RTR Grille Grille Bezel RTR Lighting kit RTR Non LED Inserts Truss head Screws 6” Cable Ties Grille Badge In addition to common hand tools, installation of this part will require the use of a body clip NOTE: Does not fit Wildtrack Ranger tool or equivalent, T-25 &...
- Page 2 T-25 TORX SPLASH SHIELD 6. Using a T-25 Torx bit, remove the two screws on 5. Remove the splash shield between the grille and the each side of the splash shield. core support. PAINTERS TAPE 7. Push the front of the shield downward and pull the 8.
- Page 3 12. Pull the grille forward, away from, and out of the tabs securing the grille to the bumper cover. vehicle. 13. Set the RTR bezel onto the RTR grille and align the 14. Press firmly onto the bezel to seat the tabs in all of mounting tabs and slots.
- Page 4 18. Align the speed nuts with the holes in the grille and 17. Route the wiring harness through the front of the Grille and insert the LED or Insert into the RTR grille. secure the LED or Insert using the 5mm screws and flat The LEDs and Inserts are side specific and are marked washers.
- Page 5 Troubleshooting tips are on page 6. to neatly route the wiring harness as shown. OPERATION: The RTR grill lamps are triggered off of the parking lamp circuit. The LEDs will be illuminated when the parking lights are on or when the headlights are turned on.
- Page 6 If you observe condensation in the lamps, keep vehicle in a dry location for 1-2 days to allow the internal pressure of the lamp to equalize. If condensation does not disappear, or moisture persists, contact RTR Vehicles. Care ...
Need help?
Do you have a question about the 1992-7001-01 and is the answer not in the manual?
Questions and answers