Setup Instructions; How To Inflate; How To Deflate; Hose Connection Instructions - Polygroup SUMMER WAVES UNICORN SPRINKLER Owner's Manual

Hide thumbs

page of 4

/ 4
Bookmarks

Available languages

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.

HOW TO INFLATE

1. Take the product out of box, and make sure all parts are included.

2. Fill water into the Base through the Drain Plug; the volume can be around 1/3 of the space. Seal the plug.

3. Inflate the Base and Horizontal Body through the other Air Valves.

4. Then seal the valve with valve lid, and press the valve into the unit to get a flat surface.

5. Connect the garden hose with the water hose connector.

NOTE: Do not use air compressor to inflate, or the product will be easily

destroyed. If the valve cannot be recessed into the unit, it may be an

indication of overinflation. Pinch valve at its base with fingers to let the

air out, then seal the valve with the valve cap, and press the valve into

the unit to get a flat surface.

HOW TO DEFLATE

Pull the valve outwards. Open the valve cap and pinch the valve

base to let out the air. When all the air has been released,

replace the cap on the valve.

Keep away from small children - small parts, choking hazard.

HOSE CONNECTION INSTRUCTIONS

For products with water sprayers or hose connectivity,

tighten the threaded hose connector to a standard

garden hose. Slowly turn the water on, and adjust to

your desired speed of rotating (if applicable).

Threaded Hose

Connector

1. To Clean: rinse with lukewarm mild soapy water and hang to dry. Never iron or brush. Do not clean with solvent cleaning agents - this will damage

the product permanently.

2. Do not drag while the product is loaded, or sharp objects can puncture.

3. To Repair: clean the repair area. Press the included repair patch firmly over the puncture/hole/leak, then wait for 30min before re-inflating.

IMPORTANT: Do not modify this product or use any parts and accessories not supplied by the manufacturer. Replace defective parts according to

the instructions of manufacturer.

4. To Drain: remove all accessories, garden hose and toys (if any). Deflate the pool, then remove the drain valve stopper and drain. You can also

push the sidewall down and inwards to empty the pool completely.

5. To Store: deflate, drain and completely air-dry the product. Gently fold, and store in a dry place away from direct sunlight. The original packing

carton can be used for storage.