Outbound 076-5560-6 Instruction Manual page 2

INSTRUCTIONS TO INFLATE
PREPARATION:
NOTE:
Please read instructions carefully before using this airbed.
INFLATION:
Using the built-in manual pump:
Approximate inflation time using
built-in pump is 5 to 7 minutes.
1. First ensure the valve is fully secured on the
inlet at the end of the mattress (FIG. 1).
FIG. 1
2. Locate the built-in manual pump and remove
the plastic screw cap and white rubber plug
from the suction port. You can use either your
hands using a "CPR method" (FIG. 2a) or your
foot (FIG. 2b) to inflate the mattress.
FIG. 2a
3. Depress the pump area to inflate the bed. Be
sure to depress the pump straight down. You
should completely cover the suction port while
depressing the pump, this will keep the air
from escaping the inflation chamber back
through the suction port.
4. Lift your hand/foot completely off of the hole in
order to have the suction port refill the
chamber. Continue until the bed reaches a
firm but not over-inflated pressure.
5. Insert the white rubber plug back into the
suction port and screw on the plastic cover.
The airbed is ready for use.
P-S-004749/14x21cm/11812/11813/11816-18/18N-OEM-567/JS-YF-2017-B-00958/英
AIRBED
Unroll the bed onto a flat area free from objects and debris.
The flocked side should be facing up and the smooth PVC side should be on the ground.
Using air pump (sold separately)
• Open the valve at the end of the mattress; inflate
the bed with an air pump and close the valve
once inflated (FIG. 3).
Note: Air pump is not included.
After use airbed may require additional air
to increase firmness, add air according to
your desired firmness.
DEFLATION:
• Open the valve to deflate (FIG. 4).
FIG. 2b
NOTE:
• It is normal that air beds will stretch and decrease
in air pressure after the first several uses. Your air
bed is not leaking. Simply add air to your desired
firmness and the air pressure will stabilize over
several uses.
• Manufacturer's Defects: Cuts, tears and punctures
are not considered a manufacturer defect and are
not covered under warranty.
• Refund Policy: For sanitary and hygienic reasons,
this product must be returned in its unopened
original packaging by the original purchaser, with
proof of purchase for a full refund.
2
FIG. 3
FIG. 4
P-S-004749