Ultra Start RFK4BAM Installation Manual

TM TM
PARTS
PROGRAMMING
REMOTE
PROGRAMMING
1
STEP
Turn the
Ignition ON then
OFF 2x leaving it in
the ON position at
the 2nd time.
ultrastarters.com
MODEL
RFK4BAM (DATA-AM ANTENNA)
ANTENNA
DATA AM
DATA PROTOCOL SELECTION
With the Antenna plugged in and powered up:
1 . Leave Ignition in OFF position
2. Press programming button (antenna button) 8x within 10 seconds (White LED will flash 2x)
3 . Choose your protocol below by pressing the programming button:
TYPE 1 - Press 2x - ULTRA RF (Default)
TYPE 2 - Press 4x - iDatalink RF
TYPE 3 - Press 6x - Fortin RF
TYPE 4 - Press 8x - D2D
TYPE 5 - Press 10x - Future Use
4 . After 3 seconds White LED will flash the number of times according to your selection.
REMOTE PROGRAMMING - ONLY REQUIRED FOR D2D
Follow the "Remote Programming Procedure" from the manufactures programming instructions.
Visit the appropriate website or download the "RFK4BAM Full Guide" at
www.ultrastarters.com
For Devices that do not have a remote coding procedure follow the procedure below.
2
STEP
2X
Press and release the Press and hold for 3 seconds
programming button on
the antenna 2 times.
The LED will flash
1x then 2x.
REMOTES
ANTENNA IN
x2
REMOTES MAY BE
DIFFERENT THAN
PICTURED
3
STEP
2X
until LED flashes turns on
solid. Release
programming button.
DAC-ADPT
RF CONN 1
BLACK - GROUND
RED - 12V+ (FUSED)
4
STEP
x1
Press the button on each
transmitter. LED on
antenna will flash 1x
for each remote
programmed.
INSTALLATION
GUIDE
RF CONN 2
RF CONN 3
5
STEP
Turn the
Ignition OFF
to exit
programming.
REV.09/20/18