Do you have a question about the The Perfect Sleep Chair and is the answer not in the manual?
Questions and answers
Roger Spencer
February 24, 2025
LED lights do not light up on controler. I can not get the chair to move. Green light is on the transformer.
1 comments:
Mr. Anderson
February 24, 2025
The LED lights on the controller of the FirstStreet Perfect Sleep Chair may not be lighting up, and the chair may not be moving despite the green light being on the transformer due to the following possible reasons:
1. Disconnected or Loose Power Cable – Ensure that the power cable from the chair is properly connected to the transformer. The power cable is located under the chair and should be securely plugged into the transformer.
2. Faulty Hand Control Connection – Check if the hand control is securely plugged in. If it is loose or disconnected, the chair may not respond.
3. Battery Backup Issue – The transformer includes a backup battery system. If the chair is not operating, check if the two 9-volt batteries are correctly installed and replace them if needed.
4. Electrical Outlet Issue – Verify that the transformer is plugged into a working 115-120V A.C. outlet. Try a different outlet if necessary.
5. Internal Chair Mechanism Issue – If all connections are correct and the issue persists, there may be an internal wiring or motor problem that requires professional service.
Checking these factors should help identify and resolve the issue.
This answer is automatically generated
philip
April 7, 2025
Where I can buy the replacement parts?
roberta blake
March 17, 2025
The recliner is stuck in the sleep mode. Is there a repair company located in NH
Susan Bugenhagen
March 12, 2025
I **** trying to get my chair re-upholstered. Is there a drawing of the electrical connections for them to use?
Ken Bryan
March 1, 2025
Can I get the wiring diagram for massage and heat.
Do you have parts if I need them.
Thanks,
Ken
Gaylon Ray Neumann
February 21, 2025
Please email me a copy of the Sleep chair Remote operation. a diagram of remote and what each button does plus how to turn off massage or heat before end of a cycle.
gaylon@remam.com
Subscribe to Our Youtube Channel
Related Manuals for FirstStreet The Perfect Sleep Chair
Summary of Contents for FirstStreet The Perfect Sleep Chair
Page 1
The Perfect Sleep Chair OWNER’S MANUAL OWNER’S MANUAL The Best Power Lift and Recline Chair Made in the USA 1-800-958-8324 1998 Ruffin Mill Road Colonial Heights, VA 23834 for Boomers and Beyond www.firststreetonline.com...
Safety Guidelines The symbols below are used in the owner’s manual and/or on the product to identify warnings and notify you of important safety information. Make sure you read and understand them completely. WARNING! Indicate(s) a hazardous situation which, if not avoided, could result in death or serious injury.
Page 3
continued from previous page Safety Guidelines Class II Device! Indoor use only! Do Not Smoke! Electrical hazard! Do not dispose in trash! Batteries required!
Page 4
MANDATORY READ THIS MANUAL FIRST BEFORE INSTALLING OR OPERATING YOUR PERFECT SLEEP CHAIR. Your power lift and recline chair has been engineered from the leg levelers up to provide the ultimate in strength and reliability. Great care has been taken to provide you with total comfort and safety.
Page 5
Do not operate the chair if there are any persons, pets or other obstructions under or in front of the footrest, under the chair or behind the chair. Do not smoke while operating, sitting or resting in the chair. To reduce risk of electrical shock, do not immerse any of the electrical components into a liquid, or spill any liquids onto electrical components.
Page 6
INSTRUCTIONS FOR THE PERFECT SLEEP CHAIR 1. Remove the transformer from the transformer box (located behind the lower outside back) and install two 9 volt alkaline batteries into the sockets on the transformer. Place transformer on the floor behind the chair.
utton ontrol peration Note that remote control designs and labeling may change over time. These changes do not limit the functionality of your chair. Refer to the manual that came with your Perfect Sleep Chair for instructions matching your specific version. 1.
Page 8
7. To lift the chair with the back L.E.D. open (back down, footrest closed), light press button (S4). Continue holding the button until the chair reaches the desired height. Then release the button. 8. To close and lift the chair from a reclined position (footrest up, back down), press button (S6).
Page 9
depending on the individual’s needs. Raise the chair high enough so you do not have to flop down into the chair. Flopping down into the chair will damage it and could cause personal injury. Press button (S3 or S5). As the chair continues downward, adjust yourself into a position that is comfortable to you.
Battery Back Up System Your Perfect Sleep Chair comes with a battery back up system so the chair can return to the seated position in the event of a household power failure. A fresh set of standard 9V batteries have enough energy to bring the chair to a seated position from either recline or lift.
CARE AND MAINTENANCE our lift chair will require routine maintenance checks. You can perform some of these checks, while others may require assistance from a provider. By following these maintenance checks, you can make sure your lift chair gives you years of trouble-free operation. If you have any questions or concerns regarding your lift chair’s care and maintenance, contact your provider.
Page 12
NOTES: The Best Power Lift and Recline Chair Made in the USA for Boomers and Beyond...
For Your reCordS Please fill in your Perfect Sleep Chair information below. This information will be useful in the event that you should ever need to contact us concerning your lift chair. Date of Purchase _____________________________________________ Model ______________________________________________________ Serial Number _______________________________________________ 1998 Ruffin Mill Road Colonial Heights, VA 23834 CAUTION...
Need help?
Do you have a question about the The Perfect Sleep Chair and is the answer not in the manual?
Questions and answers
LED lights do not light up on controler. I can not get the chair to move. Green light is on the transformer.
The LED lights on the controller of the FirstStreet Perfect Sleep Chair may not be lighting up, and the chair may not be moving despite the green light being on the transformer due to the following possible reasons:
1. Disconnected or Loose Power Cable – Ensure that the power cable from the chair is properly connected to the transformer. The power cable is located under the chair and should be securely plugged into the transformer.
2. Faulty Hand Control Connection – Check if the hand control is securely plugged in. If it is loose or disconnected, the chair may not respond.
3. Battery Backup Issue – The transformer includes a backup battery system. If the chair is not operating, check if the two 9-volt batteries are correctly installed and replace them if needed.
4. Electrical Outlet Issue – Verify that the transformer is plugged into a working 115-120V A.C. outlet. Try a different outlet if necessary.
5. Internal Chair Mechanism Issue – If all connections are correct and the issue persists, there may be an internal wiring or motor problem that requires professional service.
Checking these factors should help identify and resolve the issue.
This answer is automatically generated
Where I can buy the replacement parts?
The recliner is stuck in the sleep mode. Is there a repair company located in NH
I **** trying to get my chair re-upholstered. Is there a drawing of the electrical connections for them to use?
Can I get the wiring diagram for massage and heat. Do you have parts if I need them. Thanks, Ken
Please email me a copy of the Sleep chair Remote operation. a diagram of remote and what each button does plus how to turn off massage or heat before end of a cycle. gaylon@remam.com