Advertisement
The Atractor is designed to increase
the life of your John Deere
hydraulics.
®
Small particles of metal that are not
caught by the fluid screen can damage
moving parts. The Atractor, which is
placed inside of the screen, picks up
those small particles of metal reducing
the potential for damage.
Easy to install. Just insert the Atractor into
the transmission reservoir cross screen.
Remove metal particles from the
Atractor when you replace the fluid.
Thank you for purchasing the Atractor.
Advertisement
Table of Contents
Summary of Contents for Steinertractor Atractor
- Page 1 Easy to install. Just insert the Atractor into the transmission reservoir cross screen. Remove metal particles from the Atractor when you replace the fluid.
- Page 2 2. Pull out cross screen (Use long magnet to “fish” out metal filings along load control shaft). 3. Clean or replace cross-screen. 4. Insert Atractor opposite the suction side of screen with washer end away from suction. 5. Install Snap-Ring into screen next to washer end of Atractor.
Need help?
Do you have a question about the Atractor and is the answer not in the manual?
Questions and answers