Chapter 2 - Operations And Features - Garnet MULTIRACK 688-S Manual

CHAPTER 2 - OPERATIONS AND FEATURES

Overview
For the 810PS2 S
consists of a 688M M
interconnect cable, and a 688S (single compartment) or 688D
(dual compartment) rack controller. The gauge module is installed
inside the S
SeeLeveL Special gauge, only a 688M M
is needed. In both cases, the fiber optic cable carries a pulsed light
signal from the module to the rack controller to tell it to permit
loading. The rack controller is wired to the appropriate sockets
for connection to the loading rack. When the gauge detects an
overfill situation, the pulse light signal is turned off by the module
and the rack controller goes to non-permit, which shuts down the
loading rack.
Driver Module Operation
The 688M M
transmitter for the M
built into the 808P2. The module mounts inside the 808P2 display
enclosure and connects to the black ground wire and yellow alarm
wire from the 808P2. Alarm 4 is programmed to operate the
M R
ULTI
Warning: The module must be wired correctly to ensure
overfill protection is maintained when operated in conjunction
with the 815-UHP S
Page 4
EE
L L™ and connected to alarm 4. For the 808P2
EE EVE
808-P2 S
or 810-PS2 S
R ™ Driver Module contains only the optical
ULTI ACK
™ , the same as for the 810 model.
ACK
PILL
L L™ gauge, the M
EVE
R ™ Driver Module and, a fiber optic
ULTI ACK
L L S
EE EVE PECIAL
L L P S II
EE EVE RO ERIES
UNPLUGGED OPEN CIRCUIT
UNLOAD PTO SHUT DOWN PERMIT
HORN ALARM THERM A
MANUAL EMPTY RE-ARM BYPASS THERM B
RE-ARM PTO
VALVE ERROR ON OFF
SHORT CIRCUIT ENGINE ON MODEL 688 M
S PILL MODEL 815UHP TOP S U L TRA TM OPTIC/THERMISTOR LOADING RACK CONTROLLER
WARNING: SEE OWNERS MANUAL FOR INFORMATION ALARM CONTROLLER
REGARDING OPERATIONAL PROCEDURES!
S S
TOP
PILL
M
Controller
R ™ , since the S
ULTI ACK
S system.
TOP
R
ULTI
R ™ Driver Module
ULTI ACK
810-X Bar
Rack Plugs Wired
to M R
ULTI ACK
OPTIC POWER
OPTIC SIGNAL
ulti ack R TM
R
ULTI ACK
S
PILL TOP
™ system
ACK
To loading rack
™ module is
688 Manual