Towing The Vehicle - BMW 01 41 0 155 307 Owner's Manual

Towing the vehicle

168n
Tow fitting
The screw-in tow fitting is stored in the
onboard tool kit; be sure that it remains
in the vehicle at all times. This fitting
is designed for installation in the tow
sockets located at the front and rear of
the vehicle. It is intended for towing on
paved road surfaces only. This fitting
should not be used to pull a vehicle out
of deep snow, mud, sand, etc.
Always observe all applicable towing
laws and regulations.
Access to tow socket
Front:
Using a screwdriver, press out the cover
panel on the top part of the recess.
Rear:
Using a screwdriver, press out the cover
panel on the top part of the recess.
Screw the tow fitting in until it
bottoms firmly. If this is not done,
the threads could be damaged.
Do not tow the vehicle by any compo-
nents of the running gear, or lash them
down in any way. If you do, the compo-
nents could be damaged, leading to
possible accidents.<
Towing with a commercial tow
truck
> Do not tow with sling-type equip-
ment.
> Use wheel lift or flat bed equipment.
> Please comply with applicable state
towing laws.
Never allow passengers to ride in
a towed vehicle for any reason.
Never attach tie-down hooks, chains,
straps, or tow hooks to tie rods, control
arms, or any other part of the vehicle
suspension, as severe damage to these
components will occur, leading to
possible accidents.c
Online Edition for Part No. 01 41 0 155 307 - © 09/00 BMW AG