Download Print this page

Sony CBK-HD02 Installation Manual

Sdi/composite input and 50 pin if
Hide thumbs

Advertisement

Quick Links

SDI/COMPOSITE INPUT AND 50 PIN IF
CBK-HD02
! 警告
このマニュアルは,サービス専用です。
お客様が,このマニュアルに記載された設置や保守,点検,修理などを行うと感電や火災,人身
事故につながることがあります。
危険をさけるため,サービストレーニングを受けた技術者のみご使用ください。
設置や保守,点検,修理などを行う前に,PMW-500 に付属している下記マニュアルの「安全の
ために」を必ずお読みください。
. 取扱説明書
! WARNING
This manual is intended for qualifi ed service personnel only.
To reduce the risk of electric shock, fi re or injury, do not perform any servicing other than
that contained in the operating instructions unless you are qualifi ed to do so. Refer all
servicing to qualifi ed service personnel.
! WARNUNG
Die Anleitung ist nur für qualifi ziertes Fachpersonal bestimmt.
Alle Wartungsarbeiten dürfen nur von qualifi ziertem Fachpersonal ausgeführt werden.
Um die Gefahr eines elektrischen Schlages, Feuergefahr und Verletzungen zu
vermeiden, sind bei Wartungsarbeiten strikt die Angaben in der Anleitung zu befolgen.
Andere als die angegeben Wartungsarbeiten dürfen nur von Personen ausgeführt
werden, die eine spezielle Befähigung dazu besitzen.
! AVERTISSEMENT
Ce manual est destiné uniquement aux personnes compétentes en charge de l'
entretien. Afi n de réduire les risques de décharge électrique, d'incendie ou de blessure
n'effectuer que les réparations indiquées dans le mode d'emploi à moins d'être qualifi é
pour en effectuer d'autres. Pour toute réparation faire appel à une personne compétente
uniquement.
INSTALLATION MANUAL
1st Edition (Revised 1)

Advertisement

loading

  Related Manuals for Sony CBK-HD02

No related manuals

  Summary of Contents for Sony CBK-HD02

  • Page 1 SDI/COMPOSITE INPUT AND 50 PIN IF CBK-HD02 ! 警告 このマニュアルは,サービス専用です。 お客様が,このマニュアルに記載された設置や保守,点検,修理などを行うと感電や火災,人身 事故につながることがあります。 危険をさけるため,サービストレーニングを受けた技術者のみご使用ください。 設置や保守,点検,修理などを行う前に,PMW-500 に付属している下記マニュアルの「安全の ために」を必ずお読みください。 . 取扱説明書 ! WARNING This manual is intended for qualifi ed service personnel only. To reduce the risk of electric shock, fi re or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualifi...
  • Page 2: Section 1 Installation

    This manual is intended for use by trained system and service engineers, and describes the information on installing the CBK-HD02. Related manuals Besides this installation manual, the following manual is prepared for CBK-HD02. . PMW-500 Operating Instructions (Supplied with PMW-500). This manual describes the application and operation of PMW-500.
  • Page 3 1-1. General Information for Installation Parts confi guration The SDI/COMPOSITE INPUT AND 50 PIN IF CBK-HD02 consists of the following parts. . RX-119 board assembly . Radiation sheets (two) . 50P CN assembly . 50P cover assembly . Tapes (two) .
  • Page 4: Installation Procedure

    Screws with stopper Screws with stopper Screws with stopper Screws with stopper 3. Install the 50P CN assembly with the supplied four screws (B2 x 5). 50P CN assembly 50P CN assembly B2 x 5 B2 x 5 1-3 (E) CBK-HD02...
  • Page 5 5. Pass the two coaxial cables and the harness of the 50P CN assembly under the harness (gray) and then through the space under the claws and clamp them with tape. Harness (gray) Harness (gray) Tape Tape Claws Claws Coaxial cables Coaxial cables Harness Harness CBK-HD02 1-4 (E)
  • Page 6 Disconnect the coaxial cable (green) Disconnect the coaxial cable (green) perpendicularly perpendicularly Hold the plug to remove. Hold the plug to remove. Do not attempt to remove by Do not attempt to remove by pulling the cable. pulling the cable. 1-5 (E) CBK-HD02...
  • Page 7 CN103 Harness Harness Coaxial cable Coaxial cable CN502 WHT CN502 WHT (green) (green) Coaxial cable Coaxial cable (black) (black) Coaxial cable (white) Coaxial cable (white) 8. Install the inside panel assembly by reversing the steps of removal. CBK-HD02 1-6 (E)
  • Page 8 9. Install the 50P cover assembly supplied with the CBK-HD02 with the screw with stopper. Screw with stopper Screw with stopper 50P cover assembly 50P cover assembly (Supplied with the (Supplied with the CBK-HD02) CBK-HD02) 1-7 (E) CBK-HD02...
  • Page 9 Check after Installation Check procedure 1. Turn on the power of PMW-500. 2. Display the “MAINTENANCE” menu on the viewfi nder referring the operating instructions supplied with PMW-500. 3. Confi rm that “CBK-HD02:Vx.xxx” is displayed on the “Version” window. CBK-HD02 1-8 (E)
  • Page 10 Printed in Japan Sony Corporation CBK-HD02 (SY) J,E 2011. 3 08 4-207-595-02 ©2010...