Banner SureCross Performance DX80N9X2S-P3 FlexPower Manual

SureCross Performance FlexPower Node
Configurable FlexPower Node with discrete and thermocouple I/O
For additional information, the most recent version of all documentation, and a complete list of accessories, refer to Banner Engineering's
website, www.bannerengineering.com/surecross.
Models Frequency
DX80N9X2S-P3
900 MHz ISM
Band
DX80N9X1S-P3E
DX80N2X2S-P3
2.4 GHz ISM
Band
DX80N2X1S-P3E
DX80...C (IP20; NEMA 1) models are also available. To order this model with an IP20 housing, add a C to the
end of the model number: DX80N9X2S-P3C.
The integrated battery models are also available without batteries. If you purchase a model without the bat-
tery, Banner Engineering recommends using the XENO XL-205F battery or equivalent. For DX99 models, on-
ly a XENO XL-205F battery is certified.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to serious
injury or death. This device does NOT include the self-checking redundant circuitry necessary to allow its
use in personnel safety applications. A sensor failure or malfunction can cause either an energized or de-
energized sensor output condition.
Important: Never Operate 1 Watt Radios Without Antennas.
To avoid damaging the radio circuitry, never power up SureCross Performance or SureCross MultiHop (1
Watt) radios without an antenna.
P/N 155863_web
Rev. C
The SureCross® wireless system is a radio frequency network with integrated I/O that can
operate in most environments and eliminate the need for wiring runs. Wireless networks are
formed around a Gateway, which acts as the wireless network master device, and one or
more Nodes.
• Wireless industrial I/O device with up to two selectable discrete inputs, one NMOS dis-
crete output, and four thermocouple inputs (defaults to J-type)
• One thermistor input used for integrated cold junction compensation (CJC)
• Selectable transmit power levels of 250 mW or 1 Watt and license-free operation up to 4
watt EIRP, with a high-gain antenna, in the U.S. and Canada for 900 MHz
• FlexPower® power options allows for +10 to 30V dc, solar, and battery power sources for
low power applications.
• DIP switches for user configuration
• Frequency Hopping Spread Spectrum (FHSS) technology and Time Division Multiple Ac-
cess (TDMA) control architecture ensure reliable data delivery within the unlicensed In-
dustrial, Scientific, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and Node, in-
cluding fully acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined conditions
Power
10 to 30V dc or battery supply mod-
ule
10 to 30V dc or integrated battery
10 to 30V dc or battery supply mod-
ule
10 to 30V dc or integrated battery
11/7/2012
Housing I/O
IP67, NEMA
6
IP54, NEMA
Inputs: Two selectable discrete, four ther-
4
mocouple, one thermistor for CJC
IP67, NEMA
Outputs: One NMOS sinking discrete
6
IP54, NEMA
4