Figure 20
1. Tie-down loops
Unloading the Machine
1.
Lower the ramp
(Figure
2.
Unload the machine from the trailer with the
heavy end up the ramp, carrying loads low
(Figure
21).
•
If the machine has a full load-carrying
attachment (e.g., bucket or adjustable forks)
or a non-load-carrying attachment (e.g.,
stump grinder), back it down the ramp.
•
If the machine has an empty load-carrying
attachment or no attachment, drive it forward
down the ramp.
Figure 21
1. Machine with full
attachment or
non-load-carrying
attachment—back the
machine down the ramp.
Lifting the Machine
You can lift the machine using the tie-down/lift loops
as lift points; refer to
Figure
g242654
19).
g204458
2. Machine with empty or
no attachment—drive the
machine forward down the
ramp.
20.
20