Advertisement
Table of Contents
- 1 Recommended H Ardware
- 2 Tin the Following Pads on the Micro Minimosd
- 3 Tin All Minimosd-Associated Pads on the PDB
- 4 Dry Fit the OSD on the PDB
- 5 Generously Tin the Tip of Your Soldering Iron
- 6 Solder the Servo Wires and Power Wires to the Top Side of the PDB
- 7 First Install the PDB Using the Metal Screws
- 8 Install the FC and Secure It down with M3X10 Standoffs
- Download this manual
Advertisement
Table of Contents
Related Manuals for RotorX Atom RX122
Summary of Contents for RotorX Atom RX122
- Page 1 Building R otorX A tom R X122 w ith R otorX P DB ...
- Page 2 Recommended h ardware: 8 x M 3x3mm s pacer 4 x M 3x10mm s pacer 4 x M 3x16mm s crews ...
- Page 3 Tin a ll m inimOSD-‐associated p ads o n t he P DB Dry f it t he O SD o n t he P DB a nd u se a p iece o f t ape t o s ecure t he m inimOSD i n p lace. A djust t he position ...
- Page 4 Generously t in t he t ip o f y our s oldering i ron, u ntil y ou g et a s mall b lob o f s older. ...
- Page 5 Solder t he s ervo w ires a nd p ower w ires t o t he t op s ide o f t he P DB ...
- Page 6 Connect t he P DB t o t he F C u sing s ervo w ires t hrough 6 c onnection p oints: E SC h eader 1 , 2 , 3 , 4 , ground ...
- Page 7 Install t he F C a nd s ecure i t d own w ith M 3x10 s tandoffs. Solder t he p ower w ires a nd s ignal w ires t o e ach r espective E SC. Solder ...
Need help?
Do you have a question about the Atom RX122 and is the answer not in the manual?
Questions and answers