PROEL U24B User Manual page 2

2: INSERT BATTERIES
2: INSERIMENTO BATTERIE
(-)
(+)
(+)
(-)
QUICK GUIDE
1. Plug the U24 receiver into the USB type A port of one of the following devices, as show in
previous page:
a) PROEL loudspeaker or mixer with a WIRELESS USB port:
- Turn down the level control of the WIRELESS channel.
- Switch on the equipment and the U24 receiver will be automatically powered.
b) Computer with Mac 10.9 or Windows 7 and more recent o.s.:
- If it's the first time that the receiver is plugged into a USB port, a few minutes will be required
to load the drivers (already included in the o.s.) and to configure the PC with the new hardware.
- The wireless receiver will be then visible in the software you use for recording as "PROEL U24
wireless receiver".
c) IOS or Android device smartphone or tablet:
- In this case an optional cable is required: for Apple devices it is a "Lightning to USB Camera
Adapter", for Android and more recent Apple devices it is "USB OTG cable". Both adapters must
have a female type-A USB to connect the U24 receiver.
2. Place two AA (LR6) alkaline batteries in the bodypack battery holder, taking care to follow the
polarity markings. We suggest to remove always the batteries when the transmitter is not used
for a long time, to prevents the corrosion of the contacts if the batteries release their contents.
3. Turn ON the bodypack by pressing the POWER/PAIR button for two seconds until the LED
indicator is on.
4. If the bodypack and the receiver have been previously paired, also the LED indicator on the U24
receiver lights on permanently and the system is ready to be used.
5. If the bodypack and the receiver have not been previously paired or if you want to use a different
channel, press and hold the PAIR button on the U24 receiver for at least 5 seconds, until its LED
indicator begins to flash: then press and hold the POWER/PAIR button on the bodypack until the
LED indicators on both units light steady, indicating that the receiver and transmitter are paired
and ready for operation.
6. Connect the HCM-38 headset microphone to the bodypack, speak or sing into it a normal
performance level and raise the level on the audio device until the desired level is reached.
7. The WM24B BODYPACK transmitter has a supplementary level control inside the battery
compartment: using the supplied screwdriver, turn down the GAIN level if you hear distortion
or turn up the GAIN level to increase the signal if it is too low.
ENGLISH
3-4: ON AND PAIRED
3-4: ACCESI E ACCOPPIATI
POWER/PAIR
3-5: ON AND NOT PAIRED
3-5: ACCESI NON ACCOPPIATI
PAIR
POWER/PAIR
STATUS
PAIR
STATUS