Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for TRENDnet TV-HW400
- Page 1 TV-HW400 Wall Mount TV-HN400 Corner Mount TV-HP400 Pole Mount TV-HC400 Ceiling Mount 06.06.2014...
-
Page 2: Before You Start
1. Before You Start Package Contents TV-HW400 Wall Mount TV-HN400 Corner Mount Ÿ Quick Installation Guide Ÿ Quick Installation Guide Ÿ Wall mount bracket Ÿ Wall mount bracket Ÿ Mounting accessories Ÿ Corner adapter Ÿ Mounting accessories TV-HP400 Pole Mount TV-HC400 Ceiling Mount Ÿ... - Page 3 2. TV-HW400 Wall Mount Components Wall Mount Bracket Mounting Accessories 5 expansion screws with nuts and washers Mounting 1. Place the arm bracket at mounting location and use it to mark screw hole locations. 2. Mark Ethernet cable hole location.
- Page 4 4. Pass Ethernet cable through the wall or through the indentation on the bottom of the mount. Leave enough slack so that the cable can pass through the bracket. If you passed cables through the wall, seal the hole with exterior grade caulking. 5.
- Page 5 3. TV-HN400 Corner Mount Note: Corner mounting is applicable to indoor/outdoor 90° corners with solid construction. Components Wall Mount Corner Adapter The corner adapter must be used together with the wall mount for corner mounting applications. Mounting Accessories 5 pan head screws and 5 expansion screws with nuts and washers.
- Page 6 Mounting 1. Install the corner adapter. 2. Place the corner adapter at mounting location and use it to mark screw hole locations. 3. Mark Ethernet cable hole location (optional). 4. Drill screw holes in the wall according to the holes of the mount and a hole for cables (optional), and then insert expansion screws into the mounting holes.
- Page 7 4. TV-HP400 Pole Mount Components Wall Mount Pole Adapter The pole adapter must be used together with the wall mount for pole mounting applications. Pole Mounting Hoops Pole mounting hoops are used for securing the pole mount adapter to the pole.
- Page 8 Mounting Accessories 5 pan head screws and spring washers. Mounting 1. Loosen the three pole mounting hoops with a flathead screwdriver. 2. Loop the hoops through the rectangular holes on the pole adapter. 3. Pull cables through the center hole. Leave enough slack so that the cable can pass through the bracket.
- Page 9 Note: For outdoor applications, please use proper waterproofing measures. 5. Install the wall mount arm by securing the wall mount arm to the pole adapter with 4 hex screws and spring washers. 6. Install the speed dome to the mount. Please refer to Section 6 for camera installation details.
- Page 10 5. TV-HC400 Ceiling Mount Components Ceiling Mount Mounting Accessories 5 expansion screws with nuts and washers. Mounting 1. Place the ceiling mount at mounting location and use it to mark screw hole locations. 2. Mark Ethernet cable hole location (optional). Optional: The Ethernet cable (and other cables) can be run through the hole in the corner adapter.
- Page 11 5. Attach the mounting base to the ceiling by aligning the screw holes of the mounting base with the expansion screws on the ceiling. 6. Secure the mounting base by using nuts and washers to tighten the four expansion screws. Note: For outdoor applications, please apply waterproof tape between the ceiling surface and mounting base and around the cable hole.
-
Page 12: Camera Installation
6. Camera Installation Before you start: Ÿ Do not hold the waterproof cables as shown in the picture below, otherwise the waterproof performance will be affected. Ÿ Check the camera package contents and make sure that the device in the package is in good condition and all the assembly parts are included. - Page 13 Installation for TV-HW400 / TV-HN400 / TV-HP400 1. Remove the protective sticker from the dome drive. 2. Hang the safety tether to the speed dome and then hook to the mount as shown in the figure below. 3. Connect Ethernet cables (and others, if applicable).
- Page 14 TV-HC400 Installation Lock Screw Safety Rope...
- Page 15 Garantia Limitada TRENDnet garante seus produtos contra defeitos em material e mão de obra, sob condições normais de uso e serviço, pelo seguinte tempo a partir da data da compra. Garantia: Garantia limitada de 1 anos. (Quando aplicável: 1 ano de garantia para adaptador de tensão, fonte e componentes de ventoinhas).
- Page 16 Product Warranty Registration If you have any questions regarding the product Please take a moment to register your installation, please contact our Technical Support. product online. Go to TRENDnet’s website at: Toll free US/Canada: 1-866-845-3673 http://www.trendnet.com/register Regional phone numbers available at www.trendnet.com/support...
Need help?
Do you have a question about the TV-HW400 and is the answer not in the manual?
Questions and answers