Cd Player Unit Section - JVC UX-T77 Service Manual

<<CD Player Unit Section>>
Removing the CD mechanism and CD servo
control P.C. board
(See Fig. 1 and 2)
1. Remove the rear panel.
2. Remove the left and right side panels.
3. Remove the CD player unit.
4. After turning back the CD player unit, remove the four
screws A retaining the CD servo control board and
shield.
5. From the connector CN601 on the CD servo control
board, disconnect the card wire outgoing from the CD
mechanism.
6. From the connector P011 on the CD mechanism P.C.
board, disconnect the connector wire outgoing from the
connector CN602 on the CD servo control board.
7. Remove the four screws B retaining the CD mechanism.
8. While sliding the CD mechanism in the arrow direction,
take turn table out so carefully that it does not come into
contact with the chassis.
A
P011
A
CD mechanism board
B B
B
Fig. 2
Solenoid
A
CN601
CN602
A
Fig. 1
CD mechanism
B
UX-T77
1-15