AtGames BLAST WD3306 Quick Start Manual

WIRELESS
P2 CONTROLLER
2.4G WIRELESS
CONTROLLER

Wireless P2 Game Controller

Appearance and Key List

The image below shows the location of the switches and buttons. Each function is outlined below.
(The illustration is for reference only. Certain controller functions are incompatible with some games.)
1 START
Press the button to start the game and press it again to pause.
Directional Pad (D-Pad)
2
Directional Pad for game playing.
Power Indicator
3
Press any key and the indicator will light up if there
is still battery power left in the controller.
Power
4
Turn the controller's power ON/OFF.
How To pair the controller with
the BLAST! HDMI dongle
1
Press and hold Game key
Turn the
A and press Up on D-pad for
controller's
5 seconds until the power
power off.
indicator starts blinking
after completing Step 3.
NOTE : If the controller is not working, the batteries may have run out. Please change the batteries.
How TO confirm the wireless controller
connects to the BLAST! HDMI dongle
1
Insert two AAA batteries into
the back of the controller.
NOTE :
1
If a controller button has not been pressed for a while, the controller will enter standby mode.
Press any button to wake the controller from standby.
Each wireless controller requires 2 AAA batteries, not included.
Controllers from previous AtGames' consoles are not supported.
HOW TO PLAY
TWO-PLAYER GAMES
1
Power on your Enter any 2-player game
Blast! dongle. using the P1 controller.
2 3
Turn the
controller's
power on.
2
2 3
Press START on
your P2 controller
to join the game.
2
4
Plug the small end
of the USB cable
into the Micro-USB
port on your HDMI
dongle.
Power on the system. Press any
button on the controller and it
will connect to the HDMI
dongle automatically.
Find out more about Blast!™ at:
https://blast.atgames.net
w w w . a
START
1
NOTE:
Button functions may vary
depending on game.
5
Plug the large end of the
USB cable into a USB
port or USB AC adapter
(not included) to turn on
the HDMI dongle.
3
The Power indicator light will
blink. Repeat for the second
controller.
t g a m e s . n e t
3
4
6
When the power
indicator stops
blinking, you
have completed
pairing.