Valor 556CLA Installation Manual

INSTALLATION MANUAL
556CLA Co-Linear Adapter
CSA approved for use with Valor 530, 534 and MF28
The 556CLA Co-Linear adapter is a fi eld installed kit
to convert listed direct vent heaters from solid coaxial
venting to fl exible 3" side by side co-linear venting
for installation into existing solid-fuel fi replaces and
chimneys. Co-linear piping can only be installed into
solid-fuel burning fi replace and chimney cavities.
Have the chimney swept and the fi replace cavity
including ash dumps and clean-outs cleaned before
installing the heater and vent liners. Any creosote or
soot residue remaining in the fi replace cavity chimney
or clean-out may cause odors or stains once the
heater is installed. Consult with chimney sweep for
information on how best to clean.
The 556CLA may be fi tted to the top or rear outlet
of the 530 and 534 heaters and the rear outlet only
of the MF28 heater. Co-linear venting is for vertical
termination only.
An approved co-linear terminal cap is required to
complete the termination of the co-linear chimney
system—see allowable venting accessories chart in
heater installation manual.
Notes:
• Venting limitations and restrictors are as per those
listed for coaxial venting in the heater installation
manual, except for the MF24, which uses no restric-
tors when converted to co-linear.
• Existing gaskets can be re-used if in good condition.
If not, scrape off old gaskets and glue before install-
ing new gasket. DO NOT double-stack gaskets. New
gaskets can be held in place during assembly by
using a dab of silicone or white glue (wood / carpen-
ter's glue).
• Intake and exhaust liners must correspond between
heater and roof termination.
• Ensure liners do not sag and are not crimped when
installing.
• Do not bend liners less than 3" radius.
4000427-08
© Copyright Miles Industries Ltd., 2020
556CLA
WARNING
If the information in these instructions is
not followed exactly, a fi re or explosion
may result causing property damage,
personal injury or loss of life.
This kit must be installed or serviced by a
qualifi ed installer, service agency, or gas
supplier. These instructions are to be used
in conjunction with the main Installation
Manual for the heater it is installed on.
INSTALLER: Leave this manual with the
appliance.
CONSUMER: Retain this manual for future
reference.