Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for KLAU Geomatics KlauPPK 719 Series
- Page 1 Klau PPK 719 & 729 Series User Manual www.klauppk.com Rev- 1.00...
-
Page 2: Table Of Contents
Table of Contents Introduction............................4 Disclaimer.............................4 Overview..............................5 719 Series PPK..........................5 719 Series Wire Harness........................6 729 Series PPK..........................7 729 Series Wire Harness........................8 Antenna............................9 General Operation..........................10 Technical Specifications – 719 Series....................11 Connections............................11 Dimensions & Weight........................11 Battery Recommendations......................11 Power Input............................11 Operating Temperature........................11 Event/Top of Frame Input......................12 Antenna............................12 Micro SD Card..........................12 Main Connector..........................13... -
Page 3: Introduction
Klau products. To avoid any performance degradation or damage caused by imbalanced payloads, please follow Klau Geomatics’ guides for correct installation. As we are not able to control the end user's specific usage, installation, modification (including the use of non-specified parts), and improper use. Direct or indirect damage or injury caused by the behaviour above, our company will not cover any loss and responsibility. -
Page 4: Overview
Overview 719 Series PPK 1 – Wire harness connector 2 – Event LED (Yellow) – Illuminates when a signal from the camera is received. 3 – Power LED (Red) – Illuminates solid when unit is turned on. 4 – GPS LED (Green) – Illuminates when 5 or more satellites are being tracked. 5 –... -
Page 5: 719 Series Wire Harness
719 Series Wire Harness 1 - Klau PPK unit main connector. (Please refer to Technical Specifications page for pinout) 2 & 3 - Power Input x2 – Connects to USB power banks. 4 – Event/Top of frame Input from Camera. Note: The system has 2 isolated power inputs so a battery swap can be performed without turning off power to the device. -
Page 6: 729 Series Ppk
729 Series PPK 1 – Event LED (Yellow) – Illuminates when a signal from the camera is received. 2 - Data LED (Blue) – Flickers at a fast rate when data is being written to card. - 3 slow flashes, at 5 second intervals, indicates a card error. 3 –... -
Page 7: 729 Series Wire Harness
729 Series Wire Harness 1 - Power Input x2 – Connects to USB power banks. 2 - Event/Top of frame Input from Camera. Note: The system has 2 isolated power inputs so a battery swap can be performed without turning off power to the device. Please see the technical specifications for further information regarding batteries and power input. -
Page 8: Antenna
Antenna 1 – PPK Antenna 2 – Antenna Cable – Antenna Connection 3 – Antenna Cable – PPK Connection (719 Model only) Rev- 1.00... -
Page 9: General Operation
General Operation Run a base station on a known control point, logging GNSS data at 1 second • intervals. Measure height of antenna. - Alternatively, you can use CORS data within 20km. Turn on your system by connecting one of the USB cables to the power. •... -
Page 10: Technical Specifications - 719 Series
Technical Specifications – 719 Series Connections Antenna MCX jack receptical to SMA Plug Power Inputs USB 3.0 Camera Input (Event) Futaba Plug – 3-Pin Female Dimensions & Weight Enclosure Size 79mm x 54mm x 26mm Weight without Antenna Weight WITH Antenna 138g Battery Recommendations USB Power Bank... -
Page 11: Event/Top Of Frame Input
Technical Specifications – 719 Series Event/Top of Frame Input High Pulse Signal (White wire) Requires a rising edge pulse above 1.5v Low Pulse Signal (Red wire) Requires a falling edge pulse below 4.4v Antenna Harxon HX-CH4601A GPS L1/L2+GLONASS L1/L2 Gain:33dB Micro SD Card Recommended (included in kit) SanDisk Extreme Pro v30 - 32GB... -
Page 12: Main Connector
Technical Specifications – 719 Series Main Connector Rev- 1.00... -
Page 13: Technical Specifications - 729 Series
Technical Specifications – 729 Series Connections Antenna SMA Plug Power Inputs USB 3.0 Camera Input (Event) Futaba Plug – 3-Pin Female Dimensions & Weight Enclosure Size 120mm x 73mm x 30mm Weight without Antenna 170g Weight WITH Antenna 189g Battery Recommendations USB Power Bank 2500mAh (Minimum) Power Input... -
Page 14: Event/Top Of Frame Input
Technical Specifications – 729 Series Event/Top of Frame Input High Pulse Signal (White wire) Requires a rising edge pulse above 1.5v Low Pulse Signal (Red wire) Requires a falling edge pulse below 4.4v Antenna Harxon HX-CH4601A GPS L1/L2+GLONASS L1/L2 Gain:33dB Micro SD Card Recommended (included in kit) SanDisk Extreme Pro v30 - 32GB... -
Page 15: Warning
Geomatics office. For information on safe disposal of electronic equipment please check your local rules and regulations with the necessary authorities. Alternatively, contact your local distributor or Klau Geomatics office. Klau Geomatics www.klauppk.com 6/50 Berry Street Nowra, NSW, 2541, Australia...