Setting The Air Outlet; Timer (Automatic Timer); Emptying The Water Tank; Terminating Operation - Clatronic CL 3716 Instruction Manual

Setting the Air Outlet

Adjust the fins to regulate the direction of discharged air.
• Use the lever on the lower fin to direct the air up / down.

Timer (Automatic Timer)

Use the timer function to set the power-on and power-off times of the
appliance. Select a time between 1 and 24 hours.
Using the Timer Function for Automatic Power-On
1. Press the button to turn on the appliance.
2. Select the operating mode, temperature and fan speed for the appli-
ance to operate in or at when powered on at the pre-set time.
3. Press the button to turn off the appliance.
4. Press the button. The number of hours flashes.
5. You can set the desired number of hours with the buttons
The setting mode is automatically exited after approx. 5 seconds. The
timer mode is activated and the
NOTE:
Do not press the button after setting the hours, as the timer opera-
tion will not be saved.
Using the Timer Function for Automatic Power-Off
1. Press the button to turn on the appliance.
2. Press the button during operation. The number of hours flashes.
3. Stellen Sie den Timer-Betrieb
NOTE:
• If you want to deactivate the set timer operation, press the
twice. The illumination of the
• You may also cancel the timer function at any time by pressing the
button to turn the appliance on / off.

Emptying the Water Tank

The appliance integrates a water tank for collecting condensation. When
the water tank is full, the pilot lamp
off in each operation mode. The fan keeps running independent of this.
CAUTION:
Do not transport the appliance while the water tank is full. Water could
get into the appliance.
For continued operation with the compressor, you must empty the water
tank. For this, you need a floor cloth, a flat bowl with a capacity for approx.
1 litre of water and the water hose supplied with the appliance.
1. Disconnect the mains plug from the wall socket.
2. Place the floor towel and the flat bowl underneath the water outlet. If
possible, set the bowl on a lower level than the appliance.
3. Remove the stopper.
4. Connect the water hose to the water outlet of the appliance. Place the
end of the hose in the bowl.
5. After the water has been discharged, remove the water hose. Use the
stopper to close the water drain on the appliance again.
6. For the other water drain repeat steps 2 - 5 as described above.

Terminating Operation

1. Press the button to turn off the appliance.
2. Disconnect the mains plug from the wall socket.

Winding Device for Power Cord

Wind the power cord around the winding device. Insert the plug into the
slots provided.
CL3716_IM_new
and .
button lights up.
ein wie zuvor im Punkt 5 beschrieben.
button
button turns off.
lights up. The compressor switches

Cleaning

WARNING:
• Always disconnect the mains plug from the wall
socket before cleaning!
• Make sure no water enters the openings of the appli-
ance during cleaning. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not spray the appliance with cleaning agents.
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.

Filters

If the appliance is in daily use, clean both filters every 2 weeks. The effi-
ciency of the appliance is no longer guaranteed if dust in the filters blocks
the air circulation.
1. There is a grille with an internal filter above and below the connection
for the exhaust hose on the back of the appliance.
2. Remove the grilles from the appliance and the filters from the grilles.
3. Vacuum the filters with a vacuum cleaner.
4. Clean the filters under running water. If necessary, use a mild deter-
gent.
5. Allow the filters to dry in the air or in a shady place.
6. Put the filters back into the grilles and attach the grilles to the appliance
once they have dried thoroughly.
CAUTION:
Do not operate the appliance without filters!

Housing

• Use a vacuum cleaner to vacuum the fins and ventilation openings.
• Wipe the housing with a slightly damp cloth.

Seasonal Cleaning and Storage

When not using the appliance for a long period of time, proceed as fol-
lows:
1. Empty the water tank as described above.
2. Operate the appliance in "Fan" mode for 2 hours in order to dry the
inside of the appliance.
3. Press the button to turn off the appliance. Disconnect the mains plug
from the wall socket.
4. Disconnect the flexible exhaust pipe from the appliance.
5. Clean the filters and the appliance as described above.
6. Cover the appliance with foil.
7. Always store the appliance out of the reach of children in a dry, well
ventilated place.
39
13.12.2018