Summary of Contents for INIM Electronics IGKNX100
- Page 1 Installation and programming manual EN 50131-6 IGKNX100 Konnex Gateway BUS Installation and programming manual...
-
Page 2: Description And Installation
+39 0735 704912 e-mail: info@inim.biz Web: www.inim.biz Any persons authorized by the manufacturer to repair or replace the parts of this system, hold authorization to work on INIM Electronics brand devices only. DCMIINE0IGKNX100 MANUAL CODE VERSION 1.00 INSIDE THE BOX •... -
Page 3: Technical Features
Terminals Terminal Type board Connection to SmartLiving RS232 Serial control panel Connection to devices via KNX BUS Konnex BUS Connection to power source POWER Power supply (not provided) Connection to LAN network. Ethernet Only for IGKNX100 programming Description and installation... -
Page 4: Installation
Positive - red connector If you intend connecting the IGKNX100 by means of a serial cable, plug the DB9 connector of the serial cable (included) into the serial port of the SmartLiving control panel and connect the three wires to the IGKNX100 as shown in table 4, Terminals using the extractable terminal board. - Page 5 CONFIGURATION device configured through dedicated IGKNX100.Configurator software that can be found in the CD attached or downloadable from http://www.inim.biz (download section). IGKNX100.Configurator software The software application allows you to configure the gateway to communicate with the Inim control panel present in the system.
- Page 6 PROGRAMMING THE and outputs are complete, you must send the configuration, via the GATEWAY Ethernet network, to the IGKNX100 gateway. In order to do so, you must select the “Tools / Program device” option; a dialog window will be shown: •...
-
Page 7: Control Panel
Installation and programming manual • the “Command addresses section allows you to configure the KNX devices which will activate actions on the SmartLiving control panel (arm partitions, activate outputs, etc.). The address of the KNX device that activates the signal/command to the SmartLiving control panel must be indicated in the edit field of the corresponding signal. -
Page 8: Factory Data
The programming LED (table 1 "K") starts blinking; wait for a time between 15 and 35 seconds, until the LED becomes ON solid. Release the PROG button. Disconnect the IGKNX100 powering. After this procedure the IGKNX100 addresses will be restored and all programmed settings will be erased. Configuration... - Page 9 Installation and programming manual Configuration...
- Page 10 Gateway BUS KNX Warranty INIM Electronics s.r.l. warrants that this product shall be free of defects in material and workmanship for a period of 24 months from the date of production. As INIM Electronics s.r.l. does not install directly the products indicated herein, and due to the possibility that they may be used with other equipment not manufactured by us;...
Need help?
Do you have a question about the IGKNX100 and is the answer not in the manual?
Questions and answers